Has anyone tried using this device ?
I have sent an installer this morning to try and install this cpe to a GrooveA-52HPn.
At first when trying to connect it, the second he click apply on the cpe the mikrotik goes to 100% cpu and crashes completely and only a reboot fixes it.
I have disabled wds on the mikrotik and now the cpe connects fine. Tp-link has made some attempt to steal design of Ubnt firmware, they have also implemented some tdma protocol.
The AP is configured as 2ghz b/g/n with 20/40Mhz channel width on 802.11 protocol as there are all kind of cpe devices. When this cpe connets in log it says it wants bridge :
All other cpe just say connected, as they are working in station mode. The bridge setting is disabled on the ap, but I also tried to enable it. The cpe just stay connected, i can see tx rate, but no rx rate and no traffic passes at all.
On the cpe I have tried setting it as client or ap client router(wisp client).

Groove v6.31?

Wlan1 configure:

Type: Wireless (Atheros AR9300)
Mode: AP Bridge
Band: 2GHz-B/G
Channel Width: 20MHz
Frequency: 2412
Wireless Protocol: 802.11
Country: Test/Japan

Change Package "Wireless-fp" for "Wireless-cm2".

TP-Link CPE210:

Mode:
AP Client Router (WISP MODE)

Static IP:
IP: 192.168.35.2
Sub: 255.255.255.0
Gateway: 192.168.35.1
DNS1: 8.8.8.8
DNS2: 8.8.4.4

Wireless Client Settings:
Mode: 802.11b/g
WDS: Disable
Channel Width: 20MHz
Country: Test Mode

http://forum.tp-link.com/showthread.php ... post165326