need to show ccq & noise floor for rb 911
which is the best way to do that
need to show ccq & noise floor for rb 911
Hello
need to show ccq & noise floor for rb 911
which is the best way to do that
need to show ccq & noise floor for rb 911
which is the best way to do that
Re: need to show ccq & noise floor for rb 911
please how i can do that
Re: need to show ccq & noise floor for rb 911
Use the proper OIDs...
You can get the OIDs for any section in the CLI:
You can get the OIDs for any section in the CLI:
Code: Select all
/interface wireless> print oid
0 tx-rate=.1.3.6.1.4.1.14988.1.1.1.3.1.2.9
rx-rate=.1.3.6.1.4.1.14988.1.1.1.3.1.3.9
ssid=.1.3.6.1.4.1.14988.1.1.1.3.1.4.9
bssid=.1.3.6.1.4.1.14988.1.1.1.3.1.5.9
client-count=.1.3.6.1.4.1.14988.1.1.1.3.1.6.9
frequency=.1.3.6.1.4.1.14988.1.1.1.3.1.7.9
band=.1.3.6.1.4.1.14988.1.1.1.3.1.8.9
noise-floor=.1.3.6.1.4.1.14988.1.1.1.3.1.9.9
overall-ccq=.1.3.6.1.4.1.14988.1.1.1.3.1.10.9
Re: need to show ccq & noise floor for rb 911
check you have the updated MIB loaded on the dude and do a snmp walk to check proper oid
create a probes like this
create a probes like this
You do not have the required permissions to view the files attached to this post.
Re: need to show ccq & noise floor for rb 911
then add services to devices using created probes
You do not have the required permissions to view the files attached to this post.
Who is online
Users browsing this forum: No registered users and 67 guests