Can someone explain wg peer client properties
There is no much explanation in official documentation
For example:
client-address and client-endpoint vs endpoint-address,
client-listen-port vs endpoint-port vs listen-port
Re: wireguard peer client-* properties
good article! but there is no answer to my question
Re: wireguard peer client-* properties
You have to understand that WG is a tunnel and so everything is double.
One set for the tunnel and one for the traffic inside that tunnel.
If you read UDP in the explaination then it describes the tunnel.
One set for the tunnel and one for the traffic inside that tunnel.
If you read UDP in the explaination then it describes the tunnel.
Re: wireguard peer client-* properties
I do understand that, but I'd like to have a formal explanation
Weird thing is that official help doesn't even mention about those properties
Weird thing is that official help doesn't even mention about those properties
Re: wireguard peer client-* properties
It looks like these properties don't affect anything
I've tried different values on both sides - nothing happens
have no idea what are they for
I've tried different values on both sides - nothing happens
have no idea what are they for
Re: wireguard peer client-* properties [SOLVED]
client-address is used for the client-server setup scenario, when the configuration is imported using a qr code for a client (for example, a phone), then this address for the wg interface is set on that device.
Added to manual https://help.mikrotik.com/docs/display/ROS/WireGuard
Added to manual https://help.mikrotik.com/docs/display/ROS/WireGuard
Re: wireguard peer client-* properties
Additional question then:
where does show-client-config appear which is mentioned in Help pages ?
I don't see it in winbox nor cli (7.13rc2)
where does show-client-config appear which is mentioned in Help pages ?
I don't see it in winbox nor cli (7.13rc2)
Re: wireguard peer client-* properties
Can you confirm that all these client-* fields are only for the client's config generation, and do not affect the tunnel operation ?client-address is used for the client-server setup scenario, when the configuration is imported using a qr code for a client (for example, a phone), then this address for the wg interface is set on that device.
Added to manual https://help.mikrotik.com/docs/display/ROS/WireGuard
-
-
mantouboji
newbie
- Posts: 47
- Joined:
- Location: Shanghai
Re: wireguard peer client-* properties
Try to change any one of client-* configuations, Apply , and then look the "Client Config" contents below, you'll get the answer.