WAIT ONE - do you mean your hapax is only acting as a switch?? The below advice presumed that your hapax3 was connected to the internet via a modem and received a public IP. Do you actually mean your connected to an upstream router which provides a private LAN in the range 10.10.10.X ???
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Disregard the below if the hapax is not needed as a router but is merely acting
as an AP switch.
The default setup of the hapax 3 is exactly what you need for an
ROUTER SETUP.
The only difference is that the default address comes as 192.168.88.1/24 and you need it as 10.10 etc........
What I recommend you do is take one port off the bridge to do any changes so it will be less painful. Also use safe mode to make changes.
https://help.mikrotik.com/docs/display/ ... Management
Enter the default config and remove ether5 as a bridge port. at the settings for /interface bridge port (remove the line)- you can always add it back later if you need it.
Then go to the address settings and add a new IP address
/ip address
add address=192.168.55.1 interface=ether5 network=192.168.55.0
Then add ether5 to the LAN interface list as a member
/interface list member
add interface=ether5 list=LAN
Then you can move your PC or laptop to ether5 directly and all you need to do is statically set your iPV4 settings to any address within that subnet so 192.168.55.5 would work just fine.
Then enter the router on ether5 to complete the config.
Change the address 192.168.88.1 interface=bridge network=192.168.88.0 to
/ip address
10.10.10.1/24 interface=bridge network=10.10.10.0
Ensure your IP DNS Settingss look like.
/ip dns
set allow-remote-requests=yes servers=1.1.1.1,8.8.8.8
Remove this static DNS Settings ( see static on right hand menu or popup)
/ip dns static
add address=192.168.88.1 comment=defconf name=router.lan
Change your IP pools probably something like 192.168.88.2-192.168.88.254 to
/ip pool
add name=default-dhcp ranges=10.10.10.2-10.10.10.254
Change your IP DHCP Server from 192.168.88.0/24 ................ to
/ip dhcp-server network
add address=10.10.10.0/24 comment=defconf dns-server=10.10.10.1 gateway=\
10.10.10.1\
+++++++++++++++++++++++++++++
That should be about it.............