Hey guys... I recently purchased a new RB450 and RB450G and had the pleasure of working with Dmitry to configure one of these units. But I'm trying to configure the second unit on my own and I'm running into some trouble. Hopefully this isnt basic stuff that I just missed in the manual--if so, my apologies.
I have the following ip addresses:
[admin@MikroTik] /ip address> print
Flags: X - disabled, I - invalid, D - dynamic
# ADDRESS NETWORK BROADCAST INTERFACE
0 10.0.0.240/24 10.0.0.0 10.0.0.255 WAN-0
1 10.0.0.253/24 10.0.0.0 10.0.0.255 LAN-1
2 10.0.1.253/24 10.0.1.0 10.0.1.255 WiFi-2
3 D 10.0.0.46/24 10.0.0.0 10.0.0.255 WAN-0
[admin@MikroTik] /ip address>
but when I plug a cable into LAN-1 (1 being the port number...0-4) I'm unable to ping the ip or access ssh. The machine I'm working from does receive an ip from dhcp server though. How can I access ssh from the second port.. or any port for that matter?
I also cant get internet access even though I've added what I think is the right stuff, but I'll figure that out after I get access to the router from this side. I can post any more screens needs, but I'm new to this so not sure which are relevant.