I am having problems implementing a basic vlan configuration in swos. I am looking to configure a dot1q trunk on Eth5 to carry VLANs 1 and 755, and to also create a VLAN access port for VLAN 755 on Eth1. Packets on Eth1 are to be tagged with 755 on ingress and stripped on egress.
Please see below my configuration and basic network diagram - any assistance you can provide in correcting the config would be greatly appreciated.
Joined: Sat Dec 23, 2006 12:38 am Posts: 37
Jasta- Did you get this to work? The reason I am asking is that I am having a similar problem and I will post it in another thread. I tried what kirshteins said here, but wasn't able to get it to work.
Users browsing this forum: No registered users and 3 guests
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum