I have try this:
unplug DC adapter.
press reset.
connect DC adapter wihout stop pressing reset
it works on RB750G, but not on RB450G. which is the correct sequence? Without Winbox of course.
Thanks
Software Reset
It is possible to reset all software configuration by short-circuiting the reset-hole during the power-up (see
ROS reset in layout diagram). No confirmation or passwords will be asked, so use with caution. This feature
can be disabled in the “system routerboard settings” menu by switching the “enable-jumper-reset”
parameter to “no”.
so, I have to close the hole, plug the jack DC and it will reset, correct?
yes, correct. put some screwdriver (or anything metal) into the hole, apply power and wait until it boots.so, I have to close the hole, plug the jack DC and it will reset, correct?
Ha ha ha.. true Normis, for most people, but for me, it's easier using netinstall, maybe because I am quite used to it.it's much easier than netinstall, by the way
too bad the office where i currently interning doesn't give an access to youtube for bandwidth reason :s