Hi Everyone,

I want to get maximum bandwidth between two locations. I have installed 2 Ubiquiti point to point transparent wireless bridge. Each carrying 30/30Mbps traffic.

My Requirement:
Each P2P link should carry one VPLS tunnel and bonds this two vpls tunnels together. Eg. P2P Link 1 tunnel id 1 and P2P link2 tunnel id 2. Can i make bonding of tunnel 1 & 2?

I made this setup but couldn't succeed. I can make 2 VPLS tunnel on one Ethernet interface of RB450G and bonds together but cannot create separate vpls tunnels over each Ethernet interface of RB450G.

Routerboard 450G V5.11 installed at each side.

Many thanks indeed.

Guys,

I need your assistance.

Regards,

JP