Good evening, I would explain to me how I do to open the correct ports to a PC or
failing that, properly activate UPnP. Right now I have these IP addresses:
((AP)) - RB433:
ADSL Gateway 1: 192.168.1.1 (UPnP Off)
ADSL 2 Gateway: 192.168.2.1 (UPnP Enabled)
eth0: 192.168.1.15
eth1: 192.168.2.6
wlan1: 192.168.4.1
wlan2: 192.168.5.1
BRIDGE-WDS (eth1 + wlan3): 192.168.3.1
((CLIENT)) - RB411U:
BRIDGE-WDS (eth1 + wlan1): 192.168.3.2
Computers on the network: 192.168.3.3 - 192.168.3.254
In AP, I have turned on NAT:
CHAIN src-nat ACTION masquerade.
I wonder as I have to configure the NAT and UPnP, for a client 192.168.3.0/24 take
ports open ports or enable UPnP.
Thanks.