Hi,
i was wounding how i could setup a mikrotik router running V7 to do the PPPoE authentication then pass the dynamic IP address onto a firewall,
ie. ISP --> Mikrotik --> Firewall(watchguard)
i have correctly configured PPPoE and see i get a IPv4 address, im just unsure how to pass the IP on. ive tried messing around with route lists by manually setting the IP i get from the ISP and pointing the gateway to Ether2.
firewall has been setup to "obtain an IP automatically"
Any assistance or insights would be greatly appreciated.
Re: PPPoE authentication then passthrough to firewall
I think it is called 'pppoe relay' which is not available on RouterOS, here are other methods you may try,
- Keep pppoe and NAT on mikrotik and change watchguard to bridge mode 'transparent mode'
https://www.watchguard.com/help/docs/he ... ode_c.html
- Double NATTing (pppoe and nat on mikrotik) and 2nd NAT on WatchGuard
PPPoE is a single threaded power hogging curse.
- Keep pppoe and NAT on mikrotik and change watchguard to bridge mode 'transparent mode'
https://www.watchguard.com/help/docs/he ... ode_c.html
- Double NATTing (pppoe and nat on mikrotik) and 2nd NAT on WatchGuard
PPPoE is a single threaded power hogging curse.
Re: PPPoE authentication then passthrough to firewall
Hi,
i was wounding how i could setup a mikrotik router running V7 to do the PPPoE authentication then pass the dynamic IP address onto a firewall,
ie. ISP --> Mikrotik --> Firewall(watchguard)
i have correctly configured PPPoE and see i get a IPv4 address, im just unsure how to pass the IP on. ive tried messing around with route lists by manually setting the IP i get from the ISP and pointing the gateway to Ether2.
firewall has been setup to "obtain an IP automatically"
Any assistance or insights would be greatly appreciated.
Ask your ISP for static public-IPV4 without PPPoE.
Who is online
Users browsing this forum: Ahrefs [Bot] and 18 guests