i want the Camera server cant see the Billing server and vice versa
The Billing server at accountant department and camera sever at other department ... the network as shown in the picture attached
thanks for your reply :) IP cameras subnet 192.168.1.0/24 servers subnet 192.168.2.0/24 IP cameras + servers connected to ether1 Billing server on ether2 camera server on ether3 i need the camera sever to be connected to IP cameras and Billing server connected to servers if its impossible to use 2 s...
hello all i have network with servers and IP cameras ... as follow Camera server -------RB433 ----- IP cameras Billing server ------- RB433 ------ servers i have one RB433 and the IP camera, servers in the same LAN but different subnets .... i need a setting for RB433 to be the servers routed to the...
sorry but i think your problem is the Fresnel zone i have link of 16 km, first i set the power at 28dBm and the signal strength was about -40dBm then i decrease it to 100mW 20dBm to set the signal strength at -60dBm, so you must have the power signal receive at least -55dBm. try to set another point...
hello;
is there any site for firmware of all Mikrotik products.
to make it easy when we need a firmware. not to search all Mikrotik forum for links
thank you
Thank you all
i tried to reduce the signal power and i found advantage in throughput and the link is good now.
i will try nstreme later
thank you all again for your support
hi all I have a 16km link 2 RB 600 ppc 3.10 with 2 XR5 600 mW with 90cm dish gain 31dB. The signal is excellent-45/-48 dBm and signal to noise about 56. The RB600 mode is ap bridge / bridge Turbo mode 5 GHz. The problem is the throughput is very low about 6Mb/s Maximum. the link ping is 1 ms when it...
hi,
i have rb1000 and i have 2 wan and 1 local ip .... i have tried these setting but all the connection was odd or even there is no balancing and only one wan working ...
i dont want to balance between them because one wan is 4Mb and the other is 1Mb
is there any setting to do this ???
thanks.
Hello! i have MT Router 2.9.6 before i enabled the web proxy and everything is working well without any errors. but after enabling the web proxy some of users cannot authorized the hotspot and error messege in the LOG said: (( Login Failed: Password is not chap encrypted )) Please any advice and tha...
Sorry but how can i modify it
i wrote this in the MT RouterOS 2.9.6.
/ip hotspot set addresses-per-mac=unlimited
but the router send that this not available
So please help me cause iam new for this networking
I have a wireless Network and all user appear with the same Mac Address in the hotspot users window.. so when they connect to the router just one client work on the internet and the other disconnected and when they try to connect the the other client disconnected ... can i disable mac address authen...