Community discussions

MUM Europe 2020

Search found 6 matches

by ChanukaD
Mon Feb 17, 2020 6:31 am
Forum: Forwarding Protocols
Topic: Maximum amount of BGP routes in MikroTik routes
Replies: 2
Views: 359

Maximum amount of BGP routes in MikroTik routes

Hi Guys, Our ISP network is expanding to another region and we are planning to use MikroTik routers as route reflector servers. In our current setup we have a MikroTik CCR1072 which holds around 1.7 Million BGP routes. ( Two tables of full internet routing table ). Upon expansion of our network we w...
by ChanukaD
Thu Apr 19, 2018 7:26 am
Forum: Forwarding Protocols
Topic: MPLS-TE tunnels not established [SOLVED]
Replies: 6
Views: 1025

Re: MPLS-TE tunnels not established [SOLVED]

You need to run RSVP protocol on cisco interfaces too, otherwise resource reservation along the path will not be possible. Also depending on what Te tunnel path type you are using, if CSPF is used then you also need to configure OSPF on Cisco to work with CSPF Thank you very much ! After enable RSV...
by ChanukaD
Thu Apr 19, 2018 5:31 am
Forum: Forwarding Protocols
Topic: OSPFv3 No route to host
Replies: 2
Views: 542

Re: OSPFv3 No route to host

Unfortunately IPv6 routing recursion has been broken for a while and is a limitation of the kernel being used. https://forum.mikrotik.com/viewtopic.php?f=14&t=42268&hilit=ipv6+recursive As a matter of fact it's a well known bug in Router OS since 2011 and unfortunately MikroTik haven't fix it yet. ...
by ChanukaD
Wed Apr 18, 2018 1:10 pm
Forum: Forwarding Protocols
Topic: OSPFv3 No route to host
Replies: 2
Views: 542

OSPFv3 No route to host

Hi guys. Recently I have been deploying IPv6 through out in our network and experiencing some difficulties when trying to reach some destinations. My setup is attached in this post. mikrotik.PNG The issue I'm facing is I cannot ping from R1 to R2 loopback address. It shows no route to host. But I ca...
by ChanukaD
Tue Dec 26, 2017 3:21 am
Forum: Forwarding Protocols
Topic: MPLS-TE tunnels not established [SOLVED]
Replies: 6
Views: 1025

Re: MPLS-TE tunnels not established [SOLVED]

You need to run RSVP protocol on cisco interfaces too, otherwise resource reservation along the path will not be possible. Also depending on what Te tunnel path type you are using, if CSPF is used then you also need to configure OSPF on Cisco to work with CSPF Thank you very much ! After enable RSV...
by ChanukaD
Thu Dec 21, 2017 1:07 pm
Forum: Forwarding Protocols
Topic: MPLS-TE tunnels not established [SOLVED]
Replies: 6
Views: 1025

MPLS-TE tunnels not established [SOLVED]

Hi all, I want to build a mpls te tunnel between our two edges. these two edges are connected to our core router. All 3 routers are MPLS enabled and running. OSPF running as IGP. I have attached the diagram for your reference. I have followed this mikrotik documetation ( https://wiki.mikrotik.com/wi...