Hello

If there are no firewall rules, then by default router will route between networks. if there are rules, then without seeing them, its hard to suggest a solution.

Egert

Hello

Is there plans to implement voltage reading support via snmp? Temp is working but no voltage readings.

Hello Has anyone tested Hex Poe real world max output per port, when 48v 1.46A supply is used ? I have one unit running with 2 ubiquiti NanoStation M5 wireless ap + DS-2DE4A225IW-DE Dom camera. Everything works fine until camera starts auto touring (ptz moving), then in hex interface goes up and dow...

Hello Could use some help with interface bonding. Currently i am testing bonding between CCR-1036 and CCR-1009. I have bonded eth1-4 on both routers, mode 802.3ad, monitoring Mii and hash is layer 3/4. With this setup i get close to 4Gbps, all good. But i would like to have cisco switch (2960x) betw...

Unplug power
hold reset button
apply power
wait until usr led starts blinking (about 5-10s)
release power.

Should be back to factory config.

Hello

Are there any fellow NetXms users in this forum? Been using NetXms after The Dude and so far very happy with it. But i would like to request some additional data from Mikrotik over ssh, but not sure how to do it in NetXms, perhaps someone has some working examples ?

Egert

Hello,

Its router basic task to route networks. Since it knows where each network is located, it can route between neworks. If you want to limit this, you need to add forward rules with drop action.

Hello


*) snmp - added "tx-ccq" ("mtxrWlStatTxCCQ") and "rx-ccq" ("mtxrWlStatRxCCQ") values;

Still not working, any eta on the fix ?

Egert

And how would i turn 123.123.123.123:1234->12.34.45.67:80 to Source Address = 123.123.123.123 Source Port = 1234 Dest Address = 12.34.45.67 Dest Port 80 So they would be searchable ?

Hello

Could i get instructions how to create splunk source type manualy ? I have splunk light (paid) and it doesent support apps (as far as i know).

Current problem is that source and dest addres fields are merged with port numbers.

Sadly not using Splunk currently, will have to check if prtg scripting will help.

Hello, I would like to ask why is the snmp not important to RouterOS developers ? Its implementation is very basic, and very different based on hardware. For example simple thing as monitoring PSU state, only ccr1009 has it, one would think its surely included on the more expensive hardware also, bu...

Hi Normis

Could you please clarify the snmp update, what is the new oid values for ccq? Could realy use them to monitor link quality.

Where can one find the new snmp values ? "snmp - added "tx-ccq" ("mtxrWlStatTxCCQ") and "rx-ccq" ("mtxrWlStatRxCCQ") values;" Its not listen under "interface wireless" or "interface wireless registration-tabel". Checked both Ap an...

Hello

Has anyone got working solution for monitoring wireless CCQ stats (TX/RQ) with PRTG?

Since there is no snmp oid for ccq i think scripting is the only way to retrive those values.

Egert

Hello Anybody else experiencing memory "leak" with dude router ? Currently monitoring about 2000 devices (mainly ping only) and it takes about 2-3 days until memory full and winbox is not responding anymore at which point i need to reboot it. Router: 1100AHx4 Dude Editon (ver 6.43.4). Trye...

Hello

As described in title, is it possible to use IPIP tunnel with stronger IpSec settings, instead of the dynamicly created one, where i can only change the pre shared secret?