*) w60g - general stability and performance improvements;

I can confirm the w60g link instability problem is fixed, I upgraded the Wireless Wire link that was the least stable on 6.47.4 from 6.46.6 to 6.47.6 and it's still stable.

I'd be careful with this one and Wireless Wire products. *) w60g - improved rate selection in low traffic conditions; is a 6.47 change and 6.47 has been terrible for 60g reliability Yes, I had to downgrade to 6.46.6, w60g links were very unstable with 6.46.7, especially Wireless Wire, but some LHG ...

OK, I sent the email.

Well, it is better than it was at full power before, but not completely stable. This is the current status of one side of the link: connected: yes frequency: 58320 remote-address: 04:D6:AA:A0:4A:0A mcs: 3 phy-rate: 962.0Mbps signal: 40 rssi: -48 tx-sector: 63 tx-sector-info: right 1.4 degrees, up 1....

One of our LHG-60ad links is only 100m long, so I had to manually set tx-power to 4 to get a stable link at the maximum rate. Unfortunately, after upgrading to latest stable firmware 6.43.2, the tx-power setting in CLI is no longer available. I tried switching to bugfix channel, but it's the same in...