Community discussions

MikroTik App

Search found 5 matches

by paulkmoore
Mon Apr 06, 2020 8:34 pm
Forum: General
Topic: VRF basics - layer 3 separation
Replies: 2
Views: 1013

Re: VRF basics - layer 3 separation

Thanks Joe - thanks for the heads up - I will make sure I deploy that way round. However, I'm still completely flummoxed by the separation of two VLAN interfaces ...
by paulkmoore
Mon Apr 06, 2020 1:43 pm
Forum: General
Topic: VRF basics - layer 3 separation
Replies: 2
Views: 1013

VRF basics - layer 3 separation

Hi all, I've been looking into segregating management traffic in my network, and have broadly taken the following steps: 1. Set up a dedicated management bridge (bridge ports, bridge vlan) 2. Set up a VLAN interface (interface vlan) 3. Set up a VRF including the access ports and the VLAN interface w...
by paulkmoore
Fri Oct 11, 2019 2:01 pm
Forum: RouterBOARD hardware
Topic: CRS328-24P-4S+RM installation of fan3 and fan4
Replies: 6
Views: 3540

Re: CRS328-24P-4S+RM installation of fan3 and fan4

Can you tell me if it worked? Is it better? I have to peaces in house but one of them made a lot of noise. So i will replaced the fans but my question is wich fan did you use? And where did you get it? Hi Thetmar, It certainly operates well and is quiet. By placing my hand next to the fan there is ...
by paulkmoore
Thu Jul 11, 2019 6:44 pm
Forum: RouterBOARD hardware
Topic: CRS328-24P-4S+RM installation of fan3 and fan4
Replies: 6
Views: 3540

Re: CRS328-24P-4S+RM installation of fan3 and fan4

Hi Metod, Thanks for the reply. The fans in the CRS328-24P-4S+RM are located on each side of the unit, so the airflow is right to left (when looking at the front of the switch). There are no rear fans or vents, so no "circling" I think. I had a response from Mikrotik support which corroborates my in...
by paulkmoore
Thu Jul 04, 2019 12:39 pm
Forum: RouterBOARD hardware
Topic: CRS328-24P-4S+RM installation of fan3 and fan4
Replies: 6
Views: 3540

CRS328-24P-4S+RM installation of fan3 and fan4

Hi all, First post here, so please feel free to redirect if required :) I've just received my CRS328-24P-4S+RM which looks excellent; however, as others have noted here the "typical" fan noise is not "house" friendly. I'm therefore planning to replace the existing two fans with Noctua NF-A4x20 PWMs....