Community discussions

MikroTik App

Search found 5 matches

by ryangibson5
Mon Feb 17, 2020 8:25 am
Forum: Beginner Basics
Topic: LTAP Mini and R11e-LoRa8
Replies: 2
Views: 1098

Re: LTAP Mini and R11e-LoRa8

The LtAP mini only has one MiniPCI-e slot. Therefore you would not be able to run GSM and LoRa simultaneously. You could install the R11e-LoRa8 in the MiniPCI-e slot and then use the build-in wlan to connect to your Wi-Fi. Alternatively look at the RBLtAP-2HnD it has more MiniPCI-e slots and you can...
by ryangibson5
Thu Feb 13, 2020 11:02 pm
Forum: Wireless Networking
Topic: Lots of crc status errors in a new RN11e lora gateway-what is the cause?
Replies: 1
Views: 1700

Re: Lots of crc status errors in a new RN11e lora gateway-what is the cause?

Hi Martin, Try adjusting your RSSI Threshold level to something closer to -65. What you are experiencing is that the signals are so low down in the noise floor that the packet gets corrupted. On your picture you can see RSSI of -119 and SNR of -9.25, these are really weak signals. If you say that yo...
by ryangibson5
Sun Jan 26, 2020 10:52 pm
Forum: Scripting
Topic: Simple script for posting to DeviceHive
Replies: 0
Views: 1773

Simple script for posting to DeviceHive

I've written a script that might be useful to someone integrating or playing on DeviceHive. Keep in mind that this script was written for a RouterBOARD mAP 2nD and you may need to change the /system parameters if you are using CRS etc. It posts temperature, CPU load and it posts Voltage without the ...
by ryangibson5
Fri Jul 12, 2019 10:27 pm
Forum: Wireless Networking
Topic: Wireless clients can't get an IP
Replies: 3
Views: 889

Re: Wireless clients can't get an IP

Don't give up in frustration. It can be solved. Try settings via a bridge with both eth and wlan in that same bridge. Setup a DHCP client for the bridge. Be careful in how you NAT internally Make sure you have Security on your wifi profile for 2.4 and 5 Ghz, There are plenty of help out here, try to...
by ryangibson5
Fri Jul 12, 2019 10:13 pm
Forum: Wireless Networking
Topic: Can I use NV2 and "normal" Wifi on the same device?
Replies: 4
Views: 812

Re: Can I use NV2 and "normal" Wifi on the same device?

Setup your wireless wire outside (building to building) then run your second network inside the building using more APs and switches depending on the floor space. Your clients could connect to the APs inside the building and you then transport the data over the 60Ghz link. Look at your wireless wire...