Yes please take your diagram and post to a new thread and I would like to help after that.

Please share a direct link to the new post then...

Do I get that right that the herein provided configuration examples work on Atheros8327-based devices (like the hAP ac²) but for the cost of losing bridging (speed) in hardware (due to the lack of VLAN filtering in hardware with some devices the devices' CPUs need to kick in)? Checked that out myse...

Apply as per my last post, then provide a full config, maybe there is a firewall rule or something preventing access. Here's the entire config I've been using so far which doesn't work: # jan/02/1970 00:09:18 by RouterOS 6.46.3 # software id = BGF7-UZLL # # model = RBD52G-5HacD2HnD /interface bridg...

Not fully tested, but this seems to work on rb2011, which has the same switch chip /interface bridge add name=bridge1 protocol-mode=none /interface vlan add interface=bridge1 name=vlan1 vlan-id=1 /interface ethernet switch port set 1 vlan-header=add-if-missing vlan-mode=secure set 2 default-vlan-id...

I've got an issue with understanding how to use VLAN 1 as a management VLAN on a Mikrotik device. ... Update: I tried a different configuration with VLAN filtering (adapted from https://forum.mikrotik.com/viewtopic.php?f=13&t=143620 ). It works. Switch is accessible on management IP in VLAN1 vi...

A bridge has two personalities, it is both like a switch and also an interface to the CPU. The VLAN interface should not be added as a member of the bridge - remove add bridge=bridge interface=OAM from under /interface bridge port Tried that, didn't work. And as said - if I use VLAN 150 instead of ...

IIRC, under /interface ethernet switch port you need to use vlan-header= leave-as-is on the Hap AC², etc Currently it is /interface ethernet switch port> pri Flags: I - invalid # NAME SWITCH VLAN-MODE VLAN-HEADER DEFAULT-VLAN-ID 0 ether1 switch1 secure add-if-missing auto 1 ether2 switch1 secure al...

I've got an issue with understanding how to use VLAN 1 as a management VLAN on a Mikrotik device. The tests I've been doing on a hAP ac² with a switch cpu which is not capable of VLAN filtering in hardware, therefore I used the approach depicted here: https://wiki.mikrotik.com/wiki/Manual:Basic_VLAN...

Thanks for the excellent post! I am new to MT and struggle a lot with the configuration of VLANs. Trying that on a hAP ac² I stumbled across https://wiki.mikrotik.com/wiki/Manual:Basic_VLAN_switching#Other_devices_with_built-in_switch_chip - it says that to keep hardware offloading on specific switc...