Upgraded an RB4011. I have 2 VLANs and 2 PPPoE WANs. Since the upgrade, the port forwarding is broken on the secondary pppoe interface. The traffic starts there are rx and tx packets, but the browsers returning ERR_SOCKET_NOT_CONNECTED. This can be fixed by turning off fasttrack, but it drops the sp...

Hi Wizards, I have to solve a task but i can't figure out, how to do it. We have multiple escape rooms in a building and multiple gamesmaker rooms. Each room has it own VLAN. Each escape room has 2 DIY IP microphone that streams raw pcm audio to a multicast address ( different address per mic ). I h...

I've upgraded a RB4011. It started to freeze once in every 1-5 hours. All leds going dark (except power) and the router just reboots. In the log i see nothing, only the "router rebooted without proper shutdown". Had to downgrade to long-term. Also upgraded several hap ac2 routers, they are...

BGP stopped working for me after upgrading to 7.1.3

Update: Just had to disable, then re-enable the ip address ranges in firewall/address list.

No, and the winbox was not open. But i poll the device via snmp with observium (read only community only). I attached an image. The long gap was because i disabled the BGP and the server could not reach the router, but all of the short red lines are there because of the port flapping. Meanwhile the ...

We also having this port flapping issue with RB5009. All connected ports are going down and up (The 2.5 and 1g ports too). Sometimes once per day, sometimes twice in 10 minutes. This is extremely uncomfortable, because this drops the pppoe connection and we have to wait 10 minutes until the pppoe se...

Any updates about this? At least an ETA?

Any updates about this? Or at least a planned release quarter year?

Is this 7.1 stable really stable? In the neighbor list the reported version is still "testing".

Hi, I have a weird issue. My setup is: ISP DSL device LAN1 -> RB4011 eth1 ( as PPPoE client ) Same DSL device LAN2 -> RB4011 eth6 ( as separated vlan and dhcp client, vlan3) RB4011 eth10 -> vlan3 + vlan23 ( my internal lan) I've enabled igmp proxy between ether6 and my internal lan, the winbox throw...

Still no updates?
I hate the Unifi ecosystem, but i can't swap them to Mikrotik AP's until they don't have r/k/v support.