To answer my own questions: *) qsfp - use sub-interface configuration for establishing link (for 40Gbps and 100Gbps links, all sub-interfaces must be enabled); Does that mean if I want to have a 40G link on the qsfp28-1 port of a CCR2216-1G-12XS-2XQ, I have to enable all qsfp28-1-{1,2,3,4} interface...
*) qsfp - use sub-interface configuration for establishing link (for 40Gbps and 100Gbps links, all sub-interfaces must be enabled); Does that mean if I want to have a 40G link on the qsfp28-1 port of a CCR2216-1G-12XS-2XQ, I have to enable all qsfp28-1-{1,2,3,4} interfaces before updating? What wil...
The help page on BGP refers to the draft-ietf-idr-bgp-open-policy for details on the local.role attribute. This draft later became RFC 9234, which not only defines the roles (and their compatibility matrix and its checking on connection establishment), but also (and more importantly) the Only-To-Cus...
I can totally confirm the observation of the OP. We have nearly 100 filter rules. Not counting jumps, there are roughly 22 "ebgp-in" and 5 "ebgp-out" for each peer (some shared). See below. Changing filters attached to only one peer can cause 10 minutes of 100% CPU load on one co...
While testing L3HW with BGP full tables on a CCR2216 running RouterOS 7.11.2 and using filter rules to control that the routes for the most used networks are offloaded, I noticed that for IPv6, the "suppress-hw-offload" attribute seems to be ignored. > /routing/route/print count where afi=...
I'm seeing the PoE overload on a RB5009UPr+S+OUT even with a SXT 5 ac - without converting to 24V! The SXT's datasheet - like the hAP ac³'s - specifies its max power consumption as 12W.
Let's see what support has to say about that (SUP-120584)
We are having issues with wireless mode=station-pseudobridge-clone and ARP replies. With 7.6, the Mikrotik RB951G-2HnD would reply to ARP requests for its own IP address with the cloned MAC address. Now it doesn't always do that, leading to very intermittent connectivity. Luckily only an unimportant...
Hi everyone, I really like the possibility to use L3HW offloading on the newer high-end devices! However, I also like to monitor my network traffic with Traffic Flow. And sadly, the two are incompatible out of the box (meaning that Traffic Flow simply doesn't see and hence doesn't report flows that ...
We had two units, A and B, both with completely different use cases and configurations. Both of them rebooted randomly. We replaced one of them (A) with a CCR1016-12S-1S+ and opened support case SUP-60993 for the other (B). Support told us to RMA, so we did, but replaced it with A to continue debugg...