can you give me table with rates : mcs-x ---- rate

http://www.cisco.com/en/US/products/ps6 ... shtml#tab1

I play with all configuration menus, i disable Nstreme and WDS, try only the station-to-apbridge mode with setting the IP to wlan interfaces, and check the TCP speed with internal Bandwidth test.

Use MPLS/VPLS.

It's bug, or...

Interference.

Hi! i'm using MT and Xr9 point multipoint, but when i enable nstreme, the troughput increase, but the link was really unstable. I must forced to 2.4 only B. and data rate 11 mbps. here are really stable, but the speed go down. Any Idea? Thanks! Augusto What board you use? I'm testing RB/133C + XR9 ...

Use RB/433AH with 2 R52, ver 3.10, wireless band - 5 Ghz (TX:5825, RX:5745). Work good, when change band to "5 Ghz - Turbo", band not changed. What trouble?

I have a mikrotik , i installed a wireless pci card , the clients with wireless cards and labtop works fine with "ap bridge" mode . the problem with AP units , like tp-link 501 & d-link 2100 cannot connect, any way to add these units ? how can i make these units to connect to mikrotik...

Nose Floor is -103 , is it too bad???

No

i have ADSL connection.
my network config :

-- ADSL Modem (Bridging mode ) ---> Wireless LAN (Bridge) ---> Mikrotik.

i try PPPoe with Mikrotik, but still cannot connected.

can some one help me, how can i do to solve this ?

Use EoIP tunnel.

I just want to create hotspot on both RB192`s. The both have a DSL connection for internet. And VPN to eachother to create a local net over wan.

In that case R52 will be quite enough.

Hi,

I currently have two RB192`s and would like to add wireless to them. But what card do i need to choose. For now i have a loose accesspoint. Is the R52 possible in the RB192 ?

400mW wireless is nice i think. But can the RB192 give this much power ?

You want create p2p link with 2 RB/192?

Whats the best cable to use outdoor?

Radiolab 8D or better LMR-400.

What can be expected of RB411?

In Turbo mode RB411 can 4 MB\s.

Some broblem, even change matstate value no make work dwl2100ap.

What value you enter?

This is about switch from Linux to Mikrotik Till now I have configuration INTERNET <Linux shaper> <RouterOS main router> <RouterOS my network cca 60 routers> desired configuration is INTERNET <RouterOS shaper> <RouterOS main router> <RouterOS my network ...> Im just wondering if this is possible an...

does this happened in real life ? a signal with -47 ?
RB333+R52H+17db sector ----- RB333+R52H+17db flat
5.8GHz and distance less than 1000m
and the signal is -67 !!!

maybe

Thanks
But the Laptop are getting connected automatic with either network...while in Range.....

Use DHCP, and MAC filter.

Thanks, but want that work in MT 3

Подозреваю что это проблема DWL-2100. В режиме клиента она прячет под свой MAC адрес все что за ней. Это можно убрать параметром matstate.

Thanks for your reply, when you say 'undedicated no problem', I assume you mean a little contention? Do you already offer this? If so how many users do you find can be attached per AP and what minimum signal level is needed to ensure 20mbps is possible most of the time? Also what about hardware? Ar...