Works via RP-SMA connector but only 2.4ghz It's probably gonna destroy your 5ghz range. As in: your lucky if you get half of the original antennas :D If you dont care about using the wifi-qcom(-ac) drivers then any dualband device should make for an alright repeater. Keep in mind if you mix wifi-qc...

Thanks for the reply guys. I didn't notice that the mAP didn't support 5ghz . Thank you So, Yeah , I goofed up the distance :( . We are only at 32 feet :D A while ago, I purchased an antenna, https://remo-electronics.com/products/remo-bas-2301-wifi/ . Works via RP-SMA connector but only 2.4ghz :( . ...

I'm currently using and very satisfied with my hAP ac3 router. Now I'm trying to help my neighbor improve their connection to my WiFi signal (802.11). They're about 25-30 feet away with minimal obstructions between our properties. I've been researching repeater options to install at their location t...

How big of impact switching to those drivers?

I did not know the chip set supported 5ghz-ax band. Thats the band I should use, if I want most squeeze right?

The hAP Ax3 product page mentions WiFi 5 , WiFi 6.

did not know how to exactly explain my situation.

I noticed that that they now have that separate wifi package. I'll swap it out for wifi-qcom-ac .

Thank you for the explanation , and the tip about excluding info.

Does this make sense? My router did not have the wifi " configuration " menu when I had setup. I will reset my wireless interfaces and then setup shop over at the wifi menu. Perhaps I'll write a script to use the values from the interface config over to wifi config , Such as SSID, Mode , B...

hAP ax3 - Lastest firmware :mrgreen: Since RouterOS 7.13 , they had added that /interface/Wifi section. My router's wireless was setup directly from the wireless interface. What would my best way to stop using the interface directly, and take advantage of Wifi ? Would best be just to Reset the wirel...

Hey guys and gals . The issue I am having is , the house behind me ( no more then 200ft away ) is receiving a very low signal -70 dBm -90 dBm at best on both 2.4ghz / 5ghz band . I have reviewed several postings pertaining to signal strength. As well as reviewing the MikroTik online manual. In attem...

Just picked up and switched my network over to the hAP ac³ . Upgraded to RouterOS 7.7 For some reason ethernet ports 2-4 are getting 100Mps ( 90Mb on the Desktop ! ) . I tried turning Auto Negotiation off and set advertising to100Gbps, this lead to lose of network. /interface ethernet export # jan/1...