the board parser will render better your config./interface wireguard add disabled=no listen-port=51880 mtu=1420 name=wireguard1 private-key=XXXXXUdzhtaQWe9tDnPmv94g/QtGM="
Leave me the time to check and finish the post...![]()
![]()
... and how are you going to conclude ?
I'll start by saying that ...
There are several versions of that board, yours seems like this one:But mine is different that what I see as RB750 here on forum . . .
/interface list member
...
...
add interface=*9 list=WAN
...
Cannot say!Something I said? Something I didn't say?
... where it came out that the Wap Ax runs just fine on 24 V, but that the L009 doesn't negotiate correctly the auto on and you need forced on to power the Wap AX.
No.IS there a way to place netinstall files on USB drive (FAT I assume), plug into hAP AC Lite and then set it to default install from there (I have no communication to issue any commands as yet).
/ip hotspot print
Then, mission accomplishedOh, that is the frame of the picture on the wall. Cable is white and running along door frame![]()
viewtopic.php?p=1098839&hilit=RTL8156are you sure for this ? in changelog no mention to this limitation7.16 recently added support for RTL8156, but for now only for x86.
*) x86 - added RTL8156 driver support;
Well, maybe it is not the same problem.I have the same problem, but I can't solve it as suggested. Downgrading also not helping. Is there any help on this?
/ip address print
/ip route print
Maybe or maybe notFor anyone interested I've used this configuration on the AP https://www.youtube.com/watch?v=6P0MDlYWR_E
Exactly.I think the thread, and the threads referenced therein, do not point to an MT device that is definetly compatible with Verizon Wireless in the USA.
Beginners (with lots of friends) throwing parties like there is no tomorrow?Beginners dont normally need more than 50 addresses ....
oh, oh:1. run it in your local environment
@jaclaz: even if that was possible, how would you do it for architecture you don't have at home (e.g. ampere)?