nobody can help me?

Hello Forum, I would like drop a website from my Hotspot. I follow these steps: http://wiki.mikrotik.com/wiki/How_to_Block_Websites_%26_Stop_Downloading_Using_Proxy And it is ok when my MT is configured like router but when The MT is configured as Hotspot It is not running. Then I have change the co...

Hello forum,

I have two internet connection in my office.

I would like that the 70% the traffic from my office goes through one internet connection and the other 30% use the other internet connection.

Any suggestion?
Thanks

Hello, I use the last version. And this is the configuration that should works. I am going to try this weekend. 1) In the access list: I have to set 'default-authentication=no', as clients will not use access-list entries, unless default-authentication is enabled. As well I have to add second rule t...

Hello,

I have change this option:
set wlan1 noise-floor-threshold=-80

But the clients with worst signal are connected still.

Regards

Hello forum, I would like configure the access-list to deny association to clients with a signal strength below -80. I have tried this configuration but it does not work: 0 mac-address=00:00:00:00:00:00 interface=all signal-range=-95.-80 authentication=no forwarding=yes ap-tx-limit=0 client-tx-limit...

Hello,

You can use 25V-56V Jack and short the JP7 jumper.
All should work, the only problem could be if you will use it with more than one high power card - it could reboot.

Regards

I have seen this post but I would like know another opinion:

http://forum.mikrotik.com//viewtopic.ph ... light=voip

Hello,

I have some IP phones in my office.

In the header of my networks office I use MT (obviously).

I would like that my SIP traffic has more priority than others.

I am not sure how I can do it.

Can somebody help me or can somebody tell me his experience??

Thanks

Hello!!! I write this post to discuss about wireless card. I would like to know the diference about R52 and SR5. I use R52 and I would like to know the advantages and disadvantages of SR5. I know that R52 works in a,b,g but SR5 works only in 5Ghz and It is more powerful (more miliwatts). I am intere...

In my log appears periodically: << unassoc data sender unauth or missing data sender deauth data sender >> Its seems a failed try of connection. I use a bridge(linksys) to connect to my MT. The bridge catches the MT´s SSID and achieves the connection but with my laptop I haven´t connection by wirele...

Hi people,

I have a bit problem with MT.

My problem is this error: "unassoc data error".

I don´t know the meaning of this error.

Can somebody help me?

Thanks!!!

Hi,

I havethe same problem.

Who can help us??

Thanks

Hi,

I am the same problem.

Who can help us??

Thanks