Hi Please could someone assist me with this? I need script to remove sip connections every hour. I have tried the following /ip firewall connection remove [/ip firewall connection find where connection-type=sip] I also tried to mark the connections and then /ip firewall connection remove [/ip firewa...

Just wanted to add my comment as I had the same problem.

I run the following script every 10 minutes.

/ip firewall connection remove [/ip firewall connection find where connection-type=sip and assured=no]

works for me at the moment. hope it helps others

Thanks for the suggestion. I will try your workaround for now.

Good day, I appear to have a problem with the PPTP server on 5.20. When restarting the PPTP connections to the server (over 100) the server tends to drop back to the default profile instead of the selected default-encryption profile. For some reason when I use the default profile my clients cannot a...

Thanks For the info

Well I have a router from the ISP acting as the gateway with public ip let say ... 41.222.222.1 and I have two interfaces from the Mikrotik Router using this gateway with Public IP's 41.222.222.2 and 41.222.222.3 and as such they both have a gateway of 41.222.222.1 The reason is that I want mail tra...

Hi all. I have a bit of a problem with my setup. My ISP gives me multiple public IP addresses and I need to configure a gateway for my mail server that does not effect the rest of the network. The problem I have is that when adding a second gateway with a routing mark (matching the mail server) the ...

Never Mind.

Seems i forgot to enable SNMP on my routers.

I'm sure this is something simple, but i cant seem to find a sollution on the forum. I have over 50 mikrotik routers that I would like to discover using dude4.0beta2 However when I run the dicovery tool it finds all my mikrotik devices as "Some Device" If I run a scan on just one of the ro...

Is the RB600 voltage monitor a hardware or software related matter?

If software... will it ever be working?

Its a major help when you have sites that are 110km away from you.... and the power company does not know when they will be onsite for repairs..

Has anything been resolved regarding this problem?


I appear to have the same problem with the R52hn cards.

I have tried everything I can think of and the when running a bandwidth test the transmitting (Sending) CCQ drops from a stable 90% right down to 2% and at most tests the connection is broken.

For the record I have, with the help of a local Mikrotik guru, managed to get the server to work without the masquerade rule. However, I cannot seem to get the RBL checking to work as the server still reports that it is receiving all mail from a local address and as such cannot check the source IP a...

OK. I have the netmap rules set up as above. And the packet counters are running, but I still have the problem where the masquerade rule below the netmap rules cause me to lose the original IP address. If I exclude the mail server's internal IP from the masquerade rule, I am unable to send/receive f...

Ok. I have done so.

Should i then not be able to use the server without the masquerade rule? I am asking because if i exclude the server's internal IP from the masquerade rule I am unable to send/receive mail.

Thanks for the reply.

Am i correct in assuming that the src-nat rule should be set to netmap to the public IP?

I have set the Netmap rules. Should I exclude the mail server IP from the internal masquerade rule? As the masquerade rule is to masquerade all requests to the internal network behind the internal interface of the Router. And as such i still loose the original IP.

I have a mail server on an internal address behind my Firewall. The problem i have is that if I DNAT all port 25 and port 110 traffic to the server, i am unable to communicate with the server if I don't masquerade my network behind the Firewalls internal Ether port. This would normally be fine, but ...