In my case works only with this command:%HOMEPATH%\Desktop\winbox.exe [Device.FirstAddress] [Device.UserName] "[Device.Password]"
I found solution and now iOS openvpn client v. (1.0.4 build 140) connects to mikrotik routeros v 6.18.
IOS settings->openvpn->advanced settings->Force AES-CBC ciphersuites (disabled this option).
Correction: the problem starts when the occupied bandwidth reaches 1/3-1/4 of total.Nv2 multilink problem starts when at least one link carries about over 1/2 or 3/4 its maximun bandwidth.
So, back to 3 years ago.how to resolve this problem:
if U have p2p bidge in 2x2 and then MT with AP - U should change 2x2 on 1x1 and change nv2 to nstreme on the bridge
Also, rebooting the monitored device, dude gets the right last value instead "0".but "last value" is always 0.
ros_command(":put [/interface wireless registration-table get number=0 signal-to-noise]")
diode , welcome to virtualap supporters community.Hi !
Also, sharing a cell tower & APs with another provider needs Virtual APs for splitted IP connectivities.
Use lastest version of firmware, it solves me a lot of issues.Good luck with nv2.
It is a complete disaster in my 100% mikrotik network. Same speed like nstreme, and clients randomly freezes (you can see them in the reg-list, but no ping, winbox, ...)
Which brand?5 in the field so far (120 degree, 5GHz), and very very pleased with the results.
http://forum.mikrotik.com/viewtopic.php?f=7&t=54005No wireless changes? Why isnt in changelog?
I've a mimo link with ubiqutiSR71+mikrotikRB, but it has a too many problems: disconnection, low modulation, low ccq (just disconnect manually and modulation goes back high).Just a question in this scenario Ubiquiti SR71-15 is better than RouterBoard R52Hn? Any experience?
Not in that link, in others yes, but they are much shorter and they have a lot of disconnections.Have u tried to use a R52Hn?radio module ubiquiti dual chain
ip firewall connection print count-only where dst-address~"^x.x.x.x:"