Now its same as 1580 L2MTU on all interfaces on both routers .Of course only on which you using.
Do I need this on all interfaces ? even not used by this Point to Point MPLS/VPLS ?Make a symmetric MTU on both routers on all interface, f.e. L2MTU. Are they all symmetric?
add area=backbone comment="Loopback IP" network=someloopbackip
.......Set MPLS L2MTU back to defaults.
Look at both end of the tunnels, are all in running state?
What happens, a pppoe scan on R3's VPLS tunnel (happens also on bridge1?) doesn't "see" the pppoe server on R1?
[INTERNET] ---> CCR1036 ---> USERS/NETWORK
How can i Block it ? Can Write Firewall rule Here ?They may potentially still send frames to stations on OTHER access points as that traffic doesn't hairpin out the same radio interfaces, but is bridged or routed as all other traffic. You'd block that via the normal firewall.
chain=forward action=drop protocol=tcp src-address=192.168.85.0/24 dst-port=21 comment=block
sry , yes , two IP address is Set on Ether3Your diagram doesn't show any IP space for 192.168.2.2.
Do you have two IP addresses on ether3? 192.168.2.2 and 172.16.16.1?
sep/15 12:33:18 system,info item added by admin sep/15 12:33:36 system,info item changed by admin sep/15 12:33:58 system,info item added by admin
i Have SiB Accounting (smartispbilling.com) but , IBS Dialer Only work with Thats Radius , Not work with SiB & PPPoE is Not working , Any have Dialer Like Thats with Good Look design ?It is able to connect via Dialup,PPTP,L2TP,PPPoE
This Option work when Run in Hotspot ?Or, read the manual.
If you use MikroTik RouterOS as an Access Point, default-forwarding is normally set to forward frames to other AP clients. This can be disabled under the wireless settings for each wireless interface card.
Couldn't change DNS Static Entry "Domain" - cannot change dynamic entry.