Community discussions

MUM Europe 2020

Search found 6 matches

by macahan
Wed Feb 07, 2007 8:35 am
Forum: General
Topic: Hacking Hotspot
Replies: 116
Views: 69212

Re: Hack PPPOE

After we implement MK-PPPOE solution we saw our SSID (even with AP mac cloned) cloned and one PPPOE server was running in that "unknown" AP. They were getting user/password/mac from our customers. We already have one great solution for this. (once it works) But I am curious to know what Mikrotik su...
by macahan
Wed Feb 07, 2007 8:23 am
Forum: General
Topic: Hotspot Dynamic NAT and Firewall issues
Replies: 4
Views: 1194

sounds like a routing issue.
Since your not nating you need to be routing. The hotspot will do proxy by default which will allow web traffic to work thanks to the ip binding that will allow you to break rules of ip.

Your public ip's routed through the router?
by macahan
Wed Dec 14, 2005 4:10 am
Forum: Wireless Networking
Topic: SR2 output power - please read
Replies: 51
Views: 15498

Under Linux you can limit the output power to 1 db, this is not correct. On a CM9 possibly because that card I'm not sure. But this is NOT the case on the SuperRange cards because the manufacture don't have that supported in the hardware. They have a 10dB offset so lowest you possible could go is 1...
by macahan
Mon Dec 12, 2005 7:09 pm
Forum: Wireless Networking
Topic: SR2 output power - please read
Replies: 51
Views: 15498

If tx power works like that, why from 0 to 17 I the signal doesn't change? Above 18-19-20-21.... there is some difference. I have equipment to measure the signal. Setting it 1 it's not 1 db but a lof more. Same problem with CM9 tip for the driver: maybe you should change tx power to set mW value in...
by macahan
Mon Jun 14, 2004 7:43 am
Forum: General
Topic: Backhaul with 5.4 MHz AP and two clients
Replies: 5
Views: 2812

signals looks to be within levels. I assume your doing routing with your setup since you say your not doing any bridging. Would help to figure out what coudl be causing the problem knowing more about your ip setup. Also when your running the test check the CPU load on the AP unit. Generally bridging...
by macahan
Mon Jun 14, 2004 7:38 am
Forum: General
Topic: Loop back interface
Replies: 5
Views: 3873

according to RFCs a IP device is supposed to always listen to the loopback. MT follows teh RFC's so you do not have to do anything to make the loopback function. It will however not show in the list of IPs which might be what is confusing you but then when your dealing with some other OS's they don'...