dayswaste
Did you get a change to make support output file, when WPA2 key changed?
I have tried to upgrade one of my boards from v5.23 to v6.x, key was upgrade without changes.
No, however I just upgraded an SXT and an Omnitik without a problem.
I've just had an instance upgrading an RB 5HnD from ROS 5.22, Firmware 3.00 to ROS 5.23, Firmware 3.02 where the WPA2 Pre-Shared Key changed to the MAC address of ether1. Not sure why.
I’ve set up a mesh workbench network using multiple RB411ARs with ros 5.5 following this wiki: http://wiki.mikrotik.com/wiki/Mesh_wds I have a gateway to the internet handing out DHCP across the mesh. This will be a hotspot at a later date. When I’m patched into the ether port of any of the RB411ARs...
I have a RouterBOARD 450 that will not boot with this message: RouterBOOT booter 2.20 RouterBoard 450 CPU frequency: 300 MHz Memory size: 32 MB Press any key within 2 seconds to enter setup.. loading kernel from nand... OK setting up elf image... OK jumping to kernel code Starting... /etc/rc.d/rc.sy...