hi,
i've noticed weird thing, that i have asymmetric transfer speed on all ethernet ports: download (at 100M FDX) is equal 100M, but upload is max 10M in one session. no matter autoneg is on or off, no matter which version of ROS is installed. FW version is 2.27.
its normal? how can i fix it?

@blake:
my question was about mrz's bgp configuration, but thanks for your advice - i try your conf.

can i use this configuration like:

not working for me too :[

my configuration:

there is: http://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks_using_MPLS now i would like to configure two MPLS 'bridges' one per each wlan card: first on wlan1, and the second one on wlan3. how can i setup LDP and VPLS? on wlan1: /mpls ldp set enabled=yes lsr-id=172.16.1.1 transport-add...

on the Ap Bridge side (rb600a): wlan1: lost connection, not polled for too long wlan1: failed to connect, on 5800, recived deauth: class 2 frame recived (6) on the Station WDS side (rb333): wlan1: disconnected, extensive data loss wlan1: connected, wants WDS wlan1: disconnected, extensive data loss ...

If you have your VPLS tunnel going only over wireless link (which is the case in wiki example), you do not have to worry about ethernet l2mtu - only l2mtu-s you care about are for interfaces that are involved in actual VPLS tunnel. And wireless has big enough l2mtu by default. Wiki example actually...

hi, here we have a scenario: http://wiki.mikrotik.com/wiki/Transparently_Bridge_two_Networks_using_MPLS there is RB433AH as Ap bridge connected to switch thru eth2 or eth3 (currently i cant use eth1). RB411A works as station, now we have informaton, that: Note: If interface does not support L2MTU sp...

I upgraded a dozen RBs (411s, 532s, 600s) last night. At least two of them--one of the 532s and one of the 600s--had this same problem upon reboot. Up on the roof at 11pm with a laptop and serial cable, I discovered that the system had powered up fine and indicated that ether1 was enabled, but I co...

Worked for me also, with winbox downgrade button. Maybe your 4.x package is broken. Check log after reboot.

works _only_ when try downgrade to 4.6 or below. problem was when i tried downgrade to 4.7

in my case downgrade is working as expected. Check weather you have correct packages uploaded.

or give more detail - what board, what Beta1 release.

x86 (alix) in both cases/sides, packages was correct.

hi, i tried 5.0beta1, but now i want back to 4.6 to compare results. the problem is: /system package downgrade does not work, also tried from webfig and old webbox. device is restarting and back again with 5.0beta1. how can i back to 4.x? do you click on "downgrade" button or only restart as on upd...

hi,

i tried 5.0beta1, but now i want back to 4.6 to compare results. the problem is:
/system package downgrade does not work, also tried from webfig and old webbox. device is restarting and back again with 5.0beta1. how can i back to 4.x?

is that taken from changelog of v5.0beta1 is included in 4.7?

hi, what is it and why i can see something like that, when configured nstereme dual: ns2-1.gif seen from ethernet side, of "alix-fuo" and this is: ns2-2.gif seen from ethernet side of another MT (alix-zeliwna). my configuration of 172.16.0.20: /interface wireless nstreme-dual add arp=enabled comment...