Big thanks for that!Yes cAPs do support redundant setups. Simply configure a second CAPsMAN exactly as the primary then in your cAPs, add the IP or name of the redundant CAPsMAN under the primary. Any changes to primary CAPsMAN have to be manually duplicated in redundant CAPsMAN.
I tried that to, no traffic comes in/out from ether2.What happens if you dont connect the public IP (WANIP) to the bridge.
Its not on my bridge and my setup works great with many vlans.
Probably because I am using routerOS and not some switch specific OS??
Yes.Just stating the obvious: the <public-ip-address> in line
surely includes subnet mask?Code: Select all/ip address add address=<public-ip-addess> interface=pub1
I got problem with all wireless protocols including 802.11, at least for RB411 (300MHz) variants and some older SXT devices.So for all comments in this post.It is 100% sure that 802.11 working well in arm wireless devices or not?
We pationally wait! , but as with everything one can not wait forever, currently we have very few customers affected, maybe 2-3.For the other Questions.......
- wait for ARM fix
- wait for spectral scan
- wait for ROS 7
or change Brand......
No joy, neither is there any bytes or packages counted up.Ok, so try to place that rule to chain prerouting of table mangle and check again.Still no joy, neither is there any bytes or packets on the forward chain rule or the nat rule.
Yes on some devices.Did you update your routerboard firmware?
Sent from my Nexus 4 using Tapatalk
Problem solved! It was some MTU/MRU values which had to be reduced.l2tp does not work using rb2011uas, it dies after 32kb of data transferred, it has been broken since 6.23 possible more early, discovered today after an incident that costed one company whole day outage
I solved it by circle the switches an putting in two cisco switches in the circle that can do STP, no loops all looking good so far.As far as I know, you can't use any STP on a CRS unless you use software bridges, which you for sure don't wan't to.
What is wireless-fp package good for ?I've done a few upgrades to both v6.14 and v6.15 over the air. Also enabled wireless-fp package, again over the air. No problems so far.
Hello Folks!ACK, same issue on x86. Downgrading didn't actually help, I had to restore the config, so beware.Routing mark does not work again.