Can you describe the configuration options of your script exactly. I mean the telegram configuration $config. Where to download all the required variables.

Hi Gustawo, We have some progress. I started the script at home and at the moment of switching traffic on ether10 w / ip route has a number of dynamic gateways (D-dynamic A-active o-OSPF). For each gateway sends email and logs and as a result I have 40 emails and logs. How to crush one? When route g...

Hi Gustavo,
I do not want to disable ether9 or 10 interface.
On ether 9 and 10 I have OSPF. Now the traffic goes to ether9 interfers and when it stops P2P traffic it switches me traffic to the second link via ethjer10.
This is like a script to investigate when all traffic has switched to ether10.

Hi, I have an OSPF routing network. On one router I have backup routes by ether10 and ether9. When the ether10 falls, the route switches to ether9. At this point in the window routing -> ospf-> routes shows me the IP gateway of the distant router 10.20.180.12. And now the question of how to send the...

I have a network based on a star topology and do not have backup links or rings, so if you well when it comes to the loop in one part of the network is to me the "RSTP" just cut off?

I have a network built on Mikrotik and Ubiquiti. Understanding that I have at all Mikrotik rstp?


Wysłane z iPad za pomocą Tapatalk

I have to run RSTP on all bridges (point-to-point) or at all mikrotikach (even end-customers providing internet)? how to set priorities? or can someone show an example?

Hello,
I have a network based on one big bridge. I do not know how to use STP Bridge Protocol. Are all devices enable STP, RSTP or none?

I joined to questions.

I use some monitoring netwatch MT and sends an SMS when down or up. Everything is working correctly. The problem is when I restart MT of netwatch, then send a lot of text messages that work MT monitored. How to eliminate text messaging after restart MT of netwatch?

How do I show signal strength eoip tunnel?

How does one go about clearing the TX/RX Drops and Errors shown under Interface List in Winbox?