Hi, I have to setup 100+ Mbs wifi link on very noisy area. now i use 2 sxt AC on 20MHZ. I will try with 40MHZ, but on 20MHZ link is more stabe. link is about 50/70Mbit. Donwload / Upload. One end is on very noisy place, second one is not. Maybe DynaDish will give more bandwidth? Or just place some s...
Hi guys, Is it possible to run Winbox from my Dropbox folder? I have 58 highsites and it would be great if i could sync my winbox between my office and my laptop. If so, which files would i need to copy to my Dropbox folder? Clive. You can move sesion folder to dopbox and then synced with many pc-s...
Hi, What is best setup scenario for setup static trunk between freenas 9.3 and CRS 226 If I set loadbalance on freenas - it is working only if I only one interface is enabled, when I enable second interface on trunk, traffic is stopped. I tryed also FEC interface on freenas, but same results. info f...
Is posible to set wlan interface to CAPsMAN on same unit like 2011? i need to conenct 9 CAP units + wlan interface on 2011 which is also CAMsMAN. I got error: 00:45:10 caps,error failed to import CAP CA certificate: cert import failed (6) 00:45:10 caps,error failed to import CAP certificate: cert im...
I use 2 SXT in PTP mode, as AP -> Station bridge. on 6.19 was issue with kernel on high load, but on 6.20rc5 was fixed and work OK
it is 20MHZ cahhnel.
50Mbit full duplex TCP , or cca 100 mbit on one direction tcp
[Ticket#2014082766000509] - SXT ac in station mode rebooted on nstream protocol.
nv2 is ok, bud half oh bandwitch
802.11 also ok, bandwitch cca 75Mbit on 20 MHz channel
6.12 broke my CRS's, had to go into serial console to reset configuration and build the config as new, system just hangs after updating. Another CRS hangs even after the reset-configuration, im trying to reproduce it so i can get an supout (if that works at least, since the switch disables ALL port...