Community discussions

MUM Europe 2020

Search found 21 matches

by broadband
Thu Jul 12, 2012 11:19 am
Forum: Wireless Networking
Topic: ADSL2 Aggregation
Replies: 8
Views: 1687

Re: ADSL2 Aggregation

Hello everyone! I would like to ask You for help on aggregating 3 ADSL2 links, if its possible in this topology. If some one can make a small tutorial using winbox, and OmniTIK should initiate pppoe connection. TY Where is the DSLAM? The best scenario is having a router using MLPPP conencted to 3 m...
by broadband
Sat May 26, 2012 12:24 pm
Forum: Virtualization
Topic: MetaROUTER stability issues on certain MIPSBE and PPC boards
Replies: 490
Views: 123922

Re: Has MikroTik given up on MetaROUTER?

My guess is that the problem could be switching (buck) regulator's transient response time or less likely output ripple. Increasing core frequency, using more on-chip resources may require faster transient response at the power pins of the Atheros (and for other SoC as well) .So it is worth checking...
by broadband
Thu May 10, 2012 1:33 pm
Forum: RouterBOARD hardware
Topic: RB2011 Announcement ?
Replies: 135
Views: 24087

Re: RB2011 Announcement ?

All of them are real interfaces! When I say "real interface" I usually talk about a dedicated MAC+PHY combination or NIC. Not necessarily the logical representation inside ROS. CPU has 1GBit channel to the 100Mbit interfaces, and one 1Gbit channel to the switch chip. So the CPU itself has two real ...
by broadband
Mon May 07, 2012 9:55 pm
Forum: Wireless Networking
Topic: Wireless N only showing 65 mbps
Replies: 2
Views: 3117

Re: Wireless N only showing 65 mbps

Hi
You should generate multiple streams. What about signal levels?Detailed config and test setup info needed.

Ali
by broadband
Mon Apr 16, 2012 8:30 pm
Forum: Forwarding Protocols
Topic: MT MPLS Capabilities
Replies: 13
Views: 3349

Re: MT MPLS Capabilities

Can Mikrotik MPLS handle more than just Ethernet? Can I stick a supported T1 or T3 card into an x86 box and transport it through MPLS to a box on the other side? If I have a box that will take a T3 and plop it onto MPLS, will MT participate in that cloud and carry it to the other side? Trying to fi...
by broadband
Mon Apr 16, 2012 7:22 pm
Forum: RouterBOARD hardware
Topic: Hardware suggestions for FTTH ISP
Replies: 8
Views: 6318

Re: Hardware suggestions for FTTH ISP

PPPoE over FTTH definitely isn't the norm. The prioritization of multiple PPPoE sessions does not typically tie into the queuing performed by Ethernet chips inside Active Ethernet switches. Personally, I would prefer doing DHCP Option 82. Are you going to try to make use of RB2011s with SFP ports ?...
by broadband
Sun Mar 18, 2012 10:56 am
Forum: General
Topic: Mikrotik and WiMAX ?
Replies: 3
Views: 2378

Re: Mikrotik and WiMAX ?

Many vendors are stopping to invest on WiMAX, some of them have already...
So, do you have a big project on WiMAX? Or what?

Ali
by broadband
Mon Feb 20, 2012 5:41 pm
Forum: General
Topic: Magazines and publications
Replies: 32
Views: 3648

Re: Magazines and publications

Lightreading.

Ali
by broadband
Sun Feb 19, 2012 11:45 am
Forum: Wireless Networking
Topic: i wanna setup a wisp in turkey
Replies: 3
Views: 913

Re: i wanna setup a wisp in turkey

Hi

Due to the current regulations You can not....at least now
There is one Wisp i know in a city named Bursa but giving it free Due to regulatiions

Ali
by broadband
Mon Feb 13, 2012 12:42 pm
Forum: Virtualization
Topic: ¿Impossible run metarouter openwrt on RB1100 AHx2 ?
Replies: 4
Views: 3986

Re: ¿Impossible run metarouter openwrt on RB1100 AHx2 ?

unfortunately MetaROUTER is not yet supported on RB1100AHx2. No ETA yet when this will be resolved.
Hi

What about metarouter on rb1100ah (P2010 cpu )?

Regards

Ali
by broadband
Tue Feb 07, 2012 4:35 pm
Forum: Wireless Networking
Topic: Wireless client roaming
Replies: 14
Views: 19992

Re: Wireless client roaming

Hi,

What about the envorinment? inside the building or outside the building? obstacles? Possible the use UBNT Rocket (TDMA must be off) with a sector antenna? Try to use the highest antenna gain as possible..

Regards

Ali
by broadband
Sat Feb 04, 2012 2:29 pm
Forum: Wireless Networking
Topic: VoIP compression
Replies: 4
Views: 1622

Re: VoIP compression

Hi
it Really needs high Processing power and Fpga seems to be the solution. Solution must be ptp anyway. All Udp packet headers for the same destination must be removed, payload should be ordered, muxed with a new header. Similar approach might be in use by some mobile operators..

Regards

Ali
by broadband
Sat Jan 21, 2012 11:06 am
Forum: Wireless Networking
Topic: E1 transfer with wireless
Replies: 11
Views: 3056

Re: E1 transfer with wireless

Hi, You should try IPMUX-1L (1xE1) or IPMUX-2L (2xE1) or IPMUX-4L (4xE1) from RAD DATA COM. depends on your number of E1 requirements. These devices can work as expected according to my practical experiences... For multipoint to point set up, you must use a device with higher E1 capacity naturally....
by broadband
Fri Jan 20, 2012 10:51 am
Forum: Wireless Networking
Topic: E1 transfer with wireless
Replies: 11
Views: 3056

Re: E1 transfer with wireless

Hi, You should try IPMUX-1L (1xE1) or IPMUX-2L (2xE1) or IPMUX-4L (4xE1) from RAD DATA COM. depends on your number of E1 requirements. These devices can work as expected according to my practical experiences... For multipoint to point set up, you must use a device with higher E1 capacity naturally.....
by broadband
Tue Sep 06, 2011 2:29 pm
Forum: RouterBOARD hardware
Topic: Where is 23dB from R52n-M
Replies: 8
Views: 1277

Re: Where is 23dB from R52n-M

Thank You. Now everything is clear, because someone mentioned 3dB of difference between one and two chain...
dBm = 10 log a, a in mW output power, base is 10 == one chain

2 chains means 10 log (a+a) = 10 log 2a = 10 log 2 + 10 log a = 3 + 10 log a (in dB), (10 log 2 = 3)

Regards

Ali
by broadband
Mon Sep 05, 2011 8:51 pm
Forum: Wireless Networking
Topic: about the omini antenna
Replies: 6
Views: 962

Re: about the omini antenna

thank you very much actually im an internet agent..i get internet service from internet company using virtual network using point to point link using flatt antenna with routerboard 433..down the setting results of my internet device..can you tell me is my link is ok to transmit the service ? i fell...
by broadband
Mon Sep 05, 2011 11:19 am
Forum: Wireless Networking
Topic: about the omini antenna
Replies: 6
Views: 962

Re: about the omini antenna

thank you very very very much to your replay 1- the users is 10-20 --> relatively low number and should not be problem. Will the number be increased? 2-targed bandwith per user..all i know is that the users ask me about download speed 30-40kb/sec they want these range of speed . with reasonable bro...
by broadband
Sun Sep 04, 2011 11:55 pm
Forum: Wireless Networking
Topic: Broadband over Power Line products.
Replies: 4
Views: 2295

Re: Broadband over Power Line products.

By multi-dwelling i mean http://en.wikipedia.org/wiki/Multi-family_residential. What is the maximum number of home plug devices that can be interconnected? Hi, Hardly remember but around 64 for Homeplug Turbo & AV chipset from Intellon... Now higher speeds available... http://support.netgear.com/ap...
by broadband
Sun Sep 04, 2011 11:45 pm
Forum: Wireless Networking
Topic: about the omini antenna
Replies: 6
Views: 962

Re: about the omini antenna

hellow my friends i would like to ask about the elevation that the omini antenna should be fitted with it suppose you live in a building with 10 meters elevation . you have an omini antenna 5 ghz / 15db you want to trasnmit internet sevice wirelessly actually in a circuit aera with one kilometer in...
by broadband
Sun Sep 04, 2011 2:26 pm
Forum: Wireless Networking
Topic: Broadband over Power Line products.
Replies: 4
Views: 2295

Re: Broadband over Power Line products.

Am looking into ways of proving Internet to Multi dwelling units and wireless is proving to be a tough choice which brings me to using Broadband over power line (BPL). Which vendor or equipment will work well with Mikrotik routers. I want to create a bridge from the router to each unit. Hi, HomePlu...