Not yet seen the 16P for saleYou can already find and purchase this product...Mikrotik are supposed to be bringing out a Netpower 16P
The EdgeSwitch manual doesn't mention any type of port aggregation, the EP-S16 has LAG ( Link Aggregation Groups ), and supposedly with load balancing
And the third time over the last 5 weeksThat thing is tricky, you think it's over and then it strikes the second time.
My 8 Port Ubiquiti does not have LAG ( Link Aggregation Groups ) so cannot test Bonding and failover.Sure there is no coordination and the links obviously will not share the traffic equally. However am sure it would help to a certain point...
Trolling comments are not useful, if you do not know the product or have nothing constructive to add do not comment.
I did not know that the new ISP was doing that, previous provider one did not.I wonder why you hadn't asked your isp before you asked here...
I would like to block all ping replies but no solution offered on the forum sees to work, everything tried so far stops the internet working.Is your current solution acceptable for you or still not so much?
No not enabled, as far as I am aware, I have nothing enabled that should be pinging the gateway.Maybe you have netwatch enabled ?
My god so it is, it was stuck underneath, so I did not see it when I lifted out the cardboard.A such cable should be in the package content of RB2011.
I have a problem with the new firmware not the old firmware I have been using for the past 4 1/2 yearsOk, I thought you had a problem. And I think it is caused by misunderstanding, not by
possible firewall issues. But when all is OK, good for you!
I have just got it to work without a bridge on a test unit which has NAT on the WAN, but on a public routed system, I can not make it work.I'm not PPPoE expert, but once I tried it in past just had to write some Route rules...
login to RB using putty on port 22 or something.i forget my usermanager password
Just tried this, still give invalid login name or passwordand reboot....Code: Select all/tool user data clear-log y rebuild y
No 40Mhz on its own channel setting only 20/40 HT Above or BelowTry with no country set in wireless setting.
P.S.paste both end configuration from this command:
ros code
/interface wireless export
Apologies, I had not entered it in the scan list correctly, it works now THANKS.paste both end configuration from this command:
ros code
/interface wireless export
They are disconnected at the moment, will do it when I have time to rig them up againpaste both end configuration from this command:
ros code
/interface wireless export
I have done that, no other frequency except those that are shown in bold type will work.You must also add 5840 to the "scan list" setting on the client end, otherwise it doesn't know which frequency to look at.
I am in the UK and I have a licence for 5.8MHzwhich country have configured ? as 5.8Ghz is not allowed in all countries you can't configure it with the wrong setting.
I know how to do the downgrade, were I get the 5.16 packages from is the problem.You can downgrade but first change to advanced mode and check the tx power level. The advanced mode is at the bottom.
http://wiki.mikrotik.com/wiki/Manual:Ro ... owngrading