Upgraded from 6.4 to 6.17 and Winbox and Webfig (http and https on nonstandard ports) both hang on connect. Logs say I have logged in successfully. I can SSH fine. [admin@master] > /system routerboard print routerboard: yes model: CCR1016-12G serial-number: 42D502D13F33 current-firmware: 3.09 upgra...

Turns out it was my ISP dropping the traffic. Guess FTP is too abused these days

Immediate thoughts - Check that you aren't running port 21 on the router itself (IP Services) and check that you don't actually need ports 21 & 20 for your application. Also remember that such NATed traffic also needs to be allowed in the forwarding chain filters. Thanks for the heads up on the...

Sorry to resurrect this old thread, but I'm trying to do a similar thing and having no success. I currently have working firewall/NAT rules to forward external port 5656 to internal port 5656 on 192.168.1.10. I'd like to also forward external port 21 to internal port 5656 on the same IP. The port fo...

I have upgraded from 5.25 to 6.1. After upgrade I cannot login using web interface using Chrome 27.0.1453.110(Linux). I got the message "ERROR: Internal Server Error" I can connect to web interface using firefox, and I can connect using ssh. Had the same problem, just clear your browser c...

Hey all, Upgraded to 6.0 from 5.17 without a hitch so far, however the System/Routerboard section of WebFig is all blank now. From what I recall, I was running firmware 2.36 and 2.39 was available but I never bothered to install it. Now I can't see the serial number or anything. If I go into the set...

Alright I'll give that a try, thanks. I feel like it should still be possible to be able to do since my old D-Link consumer router was able to do all this automatically. I would imagine it's just some special combination of rules.

When adding both of those it seemed to work, however I was then unable to access the WebFig page from my web server, which is something I'd like to be able to do. Would that now be impossible?

This is the rule I made based on the hairpin NAT wiki article: 0 chain=srcnat action=masquerade protocol=tcp src-address=192.168.1.0/24 dst-address=192.168.1.10 dst-port=80 It doesn't really make sense to me because I would think the dst-address would need to be my WAN IP, but I am probably missing ...

Thanks for the info. I still can't get #1 to work. Could you possibly give me an exact rule addition command that might do the trick? The cheap way out would be to create a static DNS entry for the hosts I use to point to the internal IP, but I'd rather not do that.

Hey guys, I've had my 450G running for a few days now and things are going great, but I have a couple small issues and questions: 1) I can't seem to get hairpin NAT working the way I want. Currently if I access my WAN IP from within the network I see the RouterOS landing page. From outside the netwo...

Well I'll be damned! The netinstall over ethernet actually worked! The first time I installed with it I was still unable to connect after it finished, but the eth2 port was working again which was promising. I went through the netinstall again but this time I unchecked "Keep old configuration&q...

No, I don't own any equipment with a serial port anymore

I made a very stupid mistake. Got a brand new RB450G, was in the process of setting it up, and proceeded to accidentally plug a PoE cable (powered by a UniFi powered PoE adapter) into the second port of the RB450G. The web interface immediately stopped responding and the unit is no longer accessible...