Hello yes I have this question too.

Similar problems. I hope it's damaged hardware & when I get a replacement it'll just work.

My cellular APN is private and doesn't carry a default route. It only forwards traffic to a pair of DMZ where proxies are located. This is a conscious architecture decision as it provides a high level of security against compromised devices interacting with Internet hosts. I have a new Chateau devic...

I also have this problem - CHRs with no Internet access. It would be nice to have a solution for this that doesn't involve me wiping out these devices and re-installing them.

I'm also looking to solve this problem, taking all inbound UDP packets on a particular port & sending them on to two destinations.

I'd also very much like Mikrotik support for the Huawei SFP ONT. This would save a lot of rack space & mess.

This is also important to me. Since shifting to 100% keys this has made it very, very difficult to work with some VPN-connected devices.

I would also like vmware tools please. Just started using a few routers on ESXi and yep, going to continue doing this.

Thanks @jarda - netinstall of 6.32.3 brought those dead routers back.

I've bricked several RB532s and a couple of 532As with the latest 6.33 - both with netinstall and by upgrading from 6.7.

Going to try downgrading them all to 5.26 using netinstall now.

What's the highest version of routeros 6.x that's known to work on RB532 (32mb RAM) with R52 wireless card?

I deployed a CRS125 and I'm afraid I'm going to have to pull it out. It's behaving extremely erratically. Not all ports will negotiate. A second IP address assigned to the switch group does not respond to pings. I've reset the software once and it's still acting unlike a RouterOS device should. @Mik...

Question to all: when we say "can't communicate" or "doesn't work", what do we mean?

I'm looking at an MPPT 60 now and I can't get the web page to fully load. It loads part-way.

Unit pings just fine. This one is attached to an RB750.

Well this bug scared the crap out of me this morning. I have 2x SXT-5hND units on the same new solar powered site. One is reading 10.3V, and another is reading 9.8V. I expect that both of them are receiving in the order of 13.4V. I'm going to have to put a remote serial port in to monitor the charge...