MikroTik

Chewers

40Mhz has more transmission room compared to 20Mhz so higher air rates and throughput. Dont forget SXT have only 10/100Tbase ethernet controller.

Chewers

Yes - why not? 5Ghz-only-N 20/40Mhz HT Above and u are good to go. Only remember to have max throughput its recommended to uz di-pole antennas (with regular antenna u will be able to run onlu chain0 so Air rate 150/150Mbps at ideal environment.

Chewers

And what speed goes through if all 0-7 ht ampdu priorities enabled?

Chewers

60% of the fresnel zone or more is needed to run stable link.

Chewers

Have u clear LOS and Fresnel zone? If u do, have u tried to change frequency? Reason u have low rx value at receiver side could be low sensitivity radio card. U should see Tx/Rx level @ dBm as well check Signal to Noise (normal should be Signal to noise 25-35dB and Tx/Rx -60/60dBm)

Chewers

Web proxy server and filter by url policy should do it..

Chewers

Little more info in studio, otherwise we cant predict what u wanna block.

Chewers

As far i know frequency band and operating FCC 2.412 - 2.462 GHz (11 channels) 5.180 - 5.240 GHz (4 channels) 5.745 - 5.825 GHz (5 channels) But with Country mode no_country_set it and superchannel it should do 4920-6100Mhz (59 channels) but keep in mind they are not an authorized operating frequenc...

Chewers

For what purpose you would want something like that? There are several low cost Gb compatible boards in market. My Favorite RB433GL only i dont like plastic Ethernet connectors..

Chewers

Flush DNS (Win+R>cmd>ipconfig /flushdns)

Chewers

Not 100% sure, but for 99% i think it will not work, as there are lot of other hw missing (transistors, resistors, synchronous buck reg. and so on and on.. )

Chewers

Are u using encryption? if u do - use AES

Chewers

What happens when u generate BT traffic on 3rd party device - ect. iperf or Mikrotik BTest?

Chewers

Yup, works fine.. Cheers

Chewers

SMA-RP question is answered by you already (Coz its designed for Rockets). Can you connect two cards to it and run them simultaneously on different frequencies? ie for Nstream dual. Yes only other side should have also dual polarization antenna Can you connect the two connectors on the same card to ...

Chewers

Should look like this. ROS V5

Chewers

Lower Tx Power (u should have around -45 to -55dBm)
Then set AP and Client:
HT Guard Interval to long
HT Extension Channel to Above Control
Select all 7 Options under HT AMPDU Priorities

Chewers

Beam width on SXT is 25° on H/E plane so shouldn't be hard to do alignment at all. Have not seen any notable speed gradation in rain/snow/cold on such a small distances. Real life speed on 2km link with SXT is 190Mbps.

Ps. Nice - easy setup tutorial

Chewers

Yes, you can, other question will your RB450 be enough. More details here
To find out your SoftID

[admin@MikroTik] /system license print

Chewers

Not sure did i catch question. So u want connent MT device to MiFi device and run it as hostpot? Then why not? only u will need at least 2 radio cards in MT device.

Chewers

Have similar problem, but in Rx Signal strength. Now its about -20°C out on street and my link shows weird readings from R52Hn card. Normal it would be -69dBm to -71dBm, but now it bounces from -77 to -96dBm. In same time don't see any speed or quality problems. Same with Signal to Noise which in no...

Chewers

Depends on your connection. With 802.11a u should get around 22-25Mbps with nv2 and wider channel u should be able to get significant more throughput.

Chewers

No idea mate, try to search for Saudi arabia erip

Chewers

What frequency you run on your link? I gues 5Ghz band, Saudi Arabia don't support the 5ghz band by regulatory driver. If u wanna use it, leave Country to no_country_set

Chewers

Yes - More about it here

Chewers

Here is million bucks question. Situation: Tower A (RB493AH) supplies tower B and C with 22dBi flat panel 5Ghz antenna @ 5180Mhz. Tower B runs R433AH with 2.4Ghz AP b/g (2427Mhz), 5Ghz AP (5300Mhz), Station WDS -> Tower A. Tower C runs RB532A with AP 2.4Ghz b/g (2457Mhz) and Station -> Tower A. When...

Chewers

Yes i use only one ANT57/PAR 5Ghz antenna. So 25dBm possible only with both chains enabled?

Chewers

Why just dont get 5.12? http://download.mikrotik.com/all_packages-ppc-5.12.zip

Chewers

In your case take a look under Country selection, try to set it on No_Country_set) and take a look on Current Tx power tab. But i have another weird problem. Recently bought R52Hn (Manual says "Output Power of up to 25dBm @ a/g/n Band") but mine runs Max 22dBm under 6Mbps. Country mode No_...

Chewers

Why not use Queues ?

Chewers

Hi lads.

Have some problem. Cant connect to AP, all the time getting authentication timeout error. Everything was ok till yesterday. Can it be caused by faulty radio card? in my case it's R5H.

Chewers

dunno who made this part so i contact retailer. Hope on RMA coz it should come with warranty.

Chewers

Yes u can, but there is louds of cards not been tested. Thos who have been tested are listed here

Chewers

Yup - feedhorn full of water. When i turned it over - water was dripping out of it. Should i RMA it or its normal?

Chewers

U can use all Atheros cards only why to use Nstreme not NV2?

Chewers

I remember previous versions of Mikrotik feed-horns had problems with condensate, but the wan i have is solid. Anyhow will take feedhorn down and try it to dry for couple days.

Chewers

Hi lads. Have weird issue. After storm link quality and overall performance went down and cant get it back. Problem is: Before storm (without thunder) my signal were around -67/68 dBm and CCQ ~100% (p throughput ~29000Kbps / Real Speed 18Mbps) but now all i can get is ~82/83 dBm and CCQ ~55% (p thro...

Chewers

Im not sure - maybe something has changed, but there are no realy 100% working solution to capture p2p (torrent) traffic. You can try implant layer7 or set to http traffic higher queue.

Maybe im wrong - if so - correct me.

Chewers

Have noticed weird problem with R5H and ROS 5.7. Before upgrade from 4.17 Signal To Noise was around 25dB, after update it dropped to 10-13dB. As well time to time have Ethernet errors like: oct/23/2011 21:14:37 interface info ether1-link up (speed 100M, half duplex) oct/23/2011 21:14:38 interface i...

Search found 39 matches

Re: RB SXT 5HnD setup help

Re: connecting 711G-5HnD and R52n-M with 40 mhz channel

Re: Annoying "control frame timeout" with RB SXT

Re: RB433

Re: RB433

Re: RB433

Re: RB433

Re: Groove Questions

Re: Better CPU on small Routerboards like 411

Re: on good wifi link i get webpage unavailble until i refre

Re: It's possible add an USB Port to RB750?

Re: Annoying "control frame timeout" with RB SXT

Re: Annoying "control frame timeout" with RB SXT

Re: Block Torrents & p2p Traffic 100% working on all version

Re: Y 2 antenna connectors.

Re: 802.11n throughput problem

Re: 802.11n throughput problem

Re: newbie question

Re: Can I upgrade my routerboard license level ?

Re: Mikrotik Hotspot MiFi

Re: R52Hn strange readings

Re: 711 with hn52 card

Re: Wireless Country: Saudi Arabia (routerOS 4.17) [SOLVED]

Re: Wireless Country: Saudi Arabia (routerOS 4.17) [SOLVED]

Re: Want to upgrade from an old version

Problem without explanation?

Re: r52hn power offset ??

Re: where i download usermanager?

Re: r52hn power offset ??

Re: Is it possible to resrtict bandwidth for ip pool

R5H faulty?

Re: Bad signal reception after storm.

Re: Can i use pci wireless card with routeros?

Re: Bad signal reception after storm.

Re: Nstreme dual help

Re: Bad signal reception after storm.

Bad signal reception after storm.

Re: traffic prioritization

Doesn't seems to work correct..