Hi all,

at the moment i have an RBLHGG-5acD-XL which is not able to operate with 10MHz bandwidth.
I think about buying an RBLHG-5HPnD-XL but want to be sure that it is possible to use it with 10MHz bandwidth.

Hope someone can help me

Br
Markus

Thanks for the info.

It´s for outdoor usage.

Br
Markus

It looks good but can i use it in germany? I can‘t find Information about the regulation details for 60 GHz

Hi all,

I have to create an RF link With a distance of 10 to 15 Meter.

Which product should i usw. for this? FIrst idea was to use an SXT 2 but what is with overmodulation due to the low distance?

Thanks for your ideas!

Br
Markus

I have an different error but it looks like that i have to install a firmware...

I can connect to WOOBM but get only the firmware update page ...

Hi all,

we have found an solution also it´s a little bit spacy...
The problem was not the RB1100AHx4 how i thought because against the CCR all RB750Gr3 worked as expected.

We have update the RB750Gr3 to 6.39.2 and that solved the problem!

I have create an support case with supout.rif.
Problem is reproducible with an direct connection between RB1100AHx4 and RB750Gr3 without NAT or something.
An direct ping shows packet loss.

Br
Markus

Hi all, i have an CCR1009-7G-1C-1S+ since 4 weeks with 6 L2TP-IPSec tunnel. Last week we have changed the CCR1009 against an RB1100AHx4. With the RB1100 we have 20 to 50 % packet loss. RB1100 runs with bugfix 6.38.7 and current 6.39.2 with the same problem. Today i have switched it back to CCR1009 w...

i checked it without the leading dot but get the same error.

Hi All, i try to get informations from the RB1100AHx4 via SNMP. I try it with the oid´s which the routerboard showing to me. [admin@NE-Router02] > system health print voltage: 23.4V current: 451mA temperature: 34C power-consumption: 10.5W psu1-voltage: 24V psu2-voltage: 24V [admin@NE-Router02] > sys...

Hi pe1chl,

i have try it out and i can seperate the interfaces. Or set "Master Port" to "none" via winbox on Interface General Tab.

Thanks for the info!

Thanks nescafe2002,

that was the solution.

Br
Markus

Hi all, i have 2 RB750Gr3 and tried to get VLAN´s via Switch chip working. I have read the following wiki article: http://wiki.mikrotik.com/wiki/Manual:Switch_Chip_Features But if i configure the vlans to the ports i will be locked out and have to reset the device ... Somebody who has examples fot s...

Hi all, i have a problem with my IPSec Policy. We have multiple Subnets behind our Routers 172.27.x.x/24 If we establish an VPN we can reach the other Side but i can´t reach my Router in the Local Network (As example fot DNS traffic). As i can see in the PacketFlow Diagram all traffic which is going...

+1

Hi,

sorry for my bad English

Since V 6.12 we can use DNS-Names for VPN Connections.
Is there an solution to use DNS Names for IPSec VPN´s?

It would be great if Mikrotik can implement this for the next release of RouterOS.

Greetings
Markus

Hey,

can you Post your configuration that others can use it?

Thanks!