I just experienced the same thing on a unit running 6.43.8 with the latest boot loader. Management is locked up but it is still natting traffic for me. I may try getting the support file if I can otherwise I will likely remove the internal SSD (which we are not currently using).

Run into issues with this latest firmware. Happens on 2011 and on RB912 so far. Version 6.43.1. Reboot, software based or power cycle, the routers get stuck in a boot loop and start sending out bootp packets wanting a net install. (etherboot) Existing routerboard settings: /system routerboard settin...

I was running a RB1100x2 with a pppoe client to my ISP and after upgrading from version 6.33.3 to 6.33.5, that pppoe session would never obtain an IP address and would bounce/reinitialize every few seconds. I had to down grade to the bug-fix version (6.32.3) to resolve.

Could you post the changelog for the updated RouterBOOT?

The URL Here: http://wiki.mikrotik.com/wiki/RouterBOOT_changelog

It only goes up to 3.22 but I am seeing 3.24 on the RB450G boards now.

Thank you,
Gabe

I have found the following issues: Speed/Duplex negotiation issue between Netmetal5 and RB1100 will not link at 1 Gb. If the same netmetal5 is connected to a CCR1036, it will negotiate at 1 Gb. I have found two instances already. If the same RB1100 model (the ones listed above experiencing link spee...

One can find benefit with the redundancy and load sharing features or find it usefull for different multihoming situations.

# 10.0.0.1 is my directly connected IP address neighbor for the default route to the internet. # 172.16.0.1 is an IP address out on the internet that I want to get to only from the provider. # If the address above goes down, I will disable the "Default Routes" routes and follow the other d...

Before anyone says it is a bad idea or to spark an entire debate on if such should or should not exist, please read RFC6296. For using mikrotik as a boarder firewall filter, NATv6 would be a good tool to ease the concerns of IPv6 deployment.

Hi, I have been seeing this problem with version 5.14. Primary router and backup routers injecting into OSPF type 2 default routes, learned by BGP. OSPF inject default metrics are 1 and 20 respective to the primary and backup routers. The other routers within the OSPF area will not receive a default...