Thanks for the interest! I tried everything but I had no result. When ever I disabled the links that were with full tx-power then it was working fine. So after a loot of experiments I decided to split the 16 links in to 4 separate boxes (and routers) the result was that I maximized the performance o...

just reboot

If you see the diagram of an omni you will see that it is like an umbrella When you are exactly under the omni you get almost nothing but if you get 200 meters away you will get a very good signal. Perhaps the sector is the best solution for you you should have the right antenna for the band to 802....

What do you mean??
I can’t cover the cm9 with foil because I would short circuit and the card could be damaged.

I found that if disable a link then almost all the other link work fine
That link has full tx-power and perhaps that’s the reason of the interference!!

Do you have visual contact?
What is the distance of the link?
To you have full tx-power?
Try to change channel

wwalcher When ever you do bandwidth test the computer that generates the packets will have 100% cpu load. Even if you have one link or more links and even if you have p4 or p3 it is the same thing it wiil always get 100% on bandwidth test. jp you are right... But think that it is very handy to have ...

I am from Greece I have a strange wireless set up with four (Four-Slot miniPCI Adapter). And 16 cm9 wireless cards. All these in a p4 2,66 Ghz. The first problem is that I have nsteme in 6 links and the cpu load average is 80% . But the most important thing is that some cards influence the others an...

one more vote for OLSR if it works out fine with no problems

The problem has also mentioned before by spirosco and me as you can see here http://forum.mikrotik.com/viewtopic.php?t=8492

I was using 2.9.24 + routing test but I uninstalled the routing test because of the problems and now I am using only the routing package

Because the summer is coming and I have a router on the roof I would like to be able to see the temperature of the CPU and of the hole system throw the motherboard sensors.
I searched in the forum and I saw that there wasn’t any solution.
Does any one know any way to make this happen??

Do you do the bwt in both directions?
see the cpu load on the 532
when you generate packages it is on 100% the load
do the bwt and see if ther is a broblem in your lan

The network 10.94.141.0/24 actually is down but its stuck on some routers bgp table and comming in to my router from the bgp neighbor 3757. I also have the same problem on my router running 2.9.24 + routing test I have sent the supout.rif to mikrotik let’s hope that they will find out what’s wrong.