i've doubt is it possible at all? no matter what i've done result is the same Rx/Tx rate spin only on lan interface (it's hairpin) /ip fi ma add action=mark-connection chain=input disabled=no in-interface=wan_if new-connection-mark=wan-con-mark passthrough=yes add action=mark-routing chain=output co...

sorry, you mean hairpin, but this case isn't it, here is little picture

i need red flow, to test exchange between wan, NOT green to test switch capabilities

Yes, it is normal behaviour. You must use the network address not node IP address. Take for example, the node IP address 192.168.1.10/30. The network address is 192.168.1.8, broadcast address is 192.168.1.11 while the two nodes IP addresses are 192.168.1.9 and 192.168.1.10. In order to represent th...

I'm trying to do bandwidth test between my two WAN interfaces on one Mikrotik, which has static ips. Splitted two PCs based on mangle route marking for specific ports (80, 443 and 5001/UDP). One PC shows IP_WAN1, the other PC shows IP_WAN2 (tested in 2ip.ru). Here starts my problems. I've started ip...

Can't set CIDR notated network address into src.address field (ip > routes > rules).

192.168.1.0/30 - okay
192.168.1.10/30 - not okay
192.168.1.20/30 - okay
192.168.1.30/30 - not okay
192.168.1.40/30 - okay
192.168.1.50/30 - not okay
192.168.1.56/30 - okay

Is it normal behavior?

Hi guys, need little help. I have an idea to mark users exceeding the speed into address-list and then limit they speed. For example using max. bandwidth for a 10 minutes at high speed. How? I know about PCQ and LB/FO/FT, but can't catch the answer in my head.

One more thing I just remembered Mikrotik have enabled IPSEC XAUTH support.. This is on my try list :) See here: http://wiki.mikrotik.com/wiki/Manual:IP/IPsec#Road_Warrior_setup_with_Mode_Conf Also no mention of Droid or IOS support.. For Windows you have Shrew VPN Client.. ON PPTP VPN Passthrough ...

Hello community. Today i've setup L2TP IPSEC tunnel and reached limitation described in IPSEC wiki: Only one L2TP/IpSec connection can be established through the NAT. Which means that only one client can connect to the sever located behind the same router. I know WHY this happens, my question is HOW...

if you read wiki article more carefully you have noticed the link to hotspot login scripts gives you proper web-address http://webasdf.dyndns.org/tor/hotspotLoginFiles.tar.gz and image links is http://www.webasdf.com/tor/openwrt-22250-tor-image.tar.gz just combine it http://webasdf.dyndns.org/tor/op...