Community discussions

MUM Europe 2020

Search found 10 matches

by mleducxit
Thu Jul 31, 2014 5:59 pm
Forum: General
Topic: DHCP Server and options
Replies: 0
Views: 789

DHCP Server and options

Hi, Mabe somebody have discussed about this in a previous topic, but how can I add some options checkup before allocate an IP address? I dont have found any subject on this. Secondly, it is possible that the DHCP Server didn't send the specific options requested? This is the debug log. Discover: 01:...
by mleducxit
Thu Jul 31, 2014 3:25 pm
Forum: General
Topic: simple question (maybe?); how to reach server?
Replies: 4
Views: 1085

Re: simple question (maybe?); how to reach server?

It's begin to be a bit too much complicated dont you think? We own a lot's of tower and RF technologies, we use PPPoE and VLAN's. Really simple. 1- Keep in mind that the PPPoE can't be routed. So that's means that your untagged VLAN have to be the PPPoE One. 2- The management can be tagged, dependen...
by mleducxit
Thu Jan 23, 2014 7:23 pm
Forum: General
Topic: New Packet flow diagram
Replies: 103
Views: 73665

Re: New Packet flow diagram

HI all, I've read many things on this forum and I've track carefully the packet flow, but one thing are still missing. The physical interface rules. Probably it's on the hardware, but try to figure out how can I bridge 5 interfaces on a CCR-1036 6.7, setup a DHCP Server attached to the bridge and co...
by mleducxit
Thu Jan 23, 2014 6:28 pm
Forum: General
Topic: WinBox Layout - How To save it?
Replies: 7
Views: 1835

Re: WinBox Layout - How To save it?

Euh.... After 55 reads, I still have no answers.

It is because no body knows how to do it or it's an unimplemented feature?

Thanks
by mleducxit
Mon Jan 20, 2014 5:37 pm
Forum: General
Topic: ethernet traffic <> VLAN traffic
Replies: 5
Views: 1218

Re: ethernet traffic <> VLAN traffic

Well i have no address assigned to ether1, therefore i should not have any untagged traffic.. How can I check this traffic? The IFace trafic is independant than the IP Address. Refer to the OSI Model, I assume than the Interface counter are the Layer2 Frames and not the Layer 3 (packets). So it doe...
by mleducxit
Mon Jan 20, 2014 5:32 pm
Forum: General
Topic: WinBox Layout - How To save it?
Replies: 7
Views: 1835

WinBox Layout - How To save it?

Hi,

Stupid question. I search a way to save my column layout per RB I manage. It is possible? Even globaly it will be help.

Thanks
by mleducxit
Wed Jan 08, 2014 10:51 pm
Forum: General
Topic: IPsec tunnel is only established in one drirection.
Replies: 8
Views: 2230

Re: IPsec tunnel is only established in one drirection.

I personally have more than one VPN connected to the same CCR and I've got this issue. The best way to solve it, it's to place somes log action following the packet flow and found where is the missing rule.
by mleducxit
Wed Jan 08, 2014 10:20 pm
Forum: General
Topic: ethernet traffic <> VLAN traffic
Replies: 5
Views: 1218

Re: ethernet traffic <> VLAN traffic

Check if some trafic passtrough the untagged ether1 interface. The SUM you said is the SUM of the parent interface + sub interfaces. The difference between the parent interface - SUM(each sub interface) are the Untagged traffic.
by mleducxit
Wed Jan 08, 2014 6:31 pm
Forum: General
Topic: More precision
Replies: 0
Views: 411

More precision

Hi, I would like to found more precision on the packet flow regarding the IPSec Policy and the Firewall. I have to connect many remote sites and we have deploy 3 CCR-1036 and 2 RB2011; all of them connected to a master CCR. The problem is that the master CCR do some SNAT and event I try to mark pack...
by mleducxit
Mon May 13, 2013 7:13 pm
Forum: The Dude
Topic: The Dude V4b3 reset configuration issue
Replies: 0
Views: 986

The Dude V4b3 reset configuration issue

Hi, Mabe I've take a look with my men eyes but by uninstall/reinstall The Dude it's seams that the defaut password was'nt reset. I've delete the entire folder, clear the Registry, check the check box Reset Configuration and I always got invalid username and password for the client. What happen? Thanks