Still no support for roaming with multiple routers ? I don't expect to work it on old ones, but with like new ones MikroTik hAP ax3 , any chance ? Theres something in changelog: *) wifiwave2 - added initial CAPsMAN support (only compatible with wifiwave2 interfaces) (CLI only); *) wifiwave2 - added ...

Bump, any news ?
If still no support then how to make it very similar to it ?

Hello Is there a seamless roaming supported by any chance? I don't mean same SSID, this setup causes short interruptions when you roam between 2 AP. True roaming like TPLINK Deco support(802.11r/v/k), where you roam between AP like being in GSM network and no single data interrupt is noticed as long...

If your devices are propetly grounded and they still getting brokent then something there is wrong. Use good shielded cable, use connectors with ground shield and make sure its connected. Use poe with proper ground (ubnt power supply esd protection work only if u have power socket grounded). Make su...

Its not faulty grouding installation, most groovie devices have included poe without possibility to ground shield - there is no metal parts on grounding connectors. There is possibility to ground this on own - ground a cable shield directly with additional cable but thats not professional option. My...

Hello We have lot of broken groovie devices every bad weather, this hardware is not resistent in any way from lighting strikes. I dont understand whats reason of POE kit included where we have NOT shielded sockets, can't prevent discharges without proper shielding/grounding. This is stupid money sav...

Is there firmware which support default gateway ?

I can't belive this switch cant be remotly managed without vpn etc.

I found out it was RB433 defect, possibly bad pieces. Once i did put older boards (RB433 but they had 1 year least), it started working.

Im started having problem after upgrade to 4.11 from 3.11/3.25. I had working link since 1 year, no single downtime, signal -71 on both sides, ccq 80% both, jumps to 65% under heavy loads. Link real performance was 20Mbit/s 2400kB/s while downloading from ftp, bit smaller while uploading. 1 side was...

Im having problem with ether2 to ether2 (possibly ether3 but i did not checked) connection on RB433 , Problem happend for me on 3 different RB433 boards. Its looks like RB433 to RB433 ethernet link its not compatible or something like this (ether link goes down). This happend sometimes: RB433 ether2...

For me it looks like internal interference (propably separation problem), your singnal levels are rly good for this range, try changing cards to normal ones (~100mw), dont use any with amplifiers, they cause more peoblems than benifits if they are in close to each other, then try running test, if st...

Hello.
I found out that 4.6 version crashes winbox while using virtual ap features. Winbox simply closing window, that makes unable to manage virtialap by winbox. It worked fine at 4.5.
Any fixes ?

Depends alots, try doing that in N, use highpower cards like 27dbi and 1m antenna least, for 30km link worked for me, 100% ccq, there is only about 300meters of forest which block los.

Hello I would like to share some information i got on 4.0-4.5 version. These version are broken. 4.0 - 4.4 have big problems with connection stability on long links or not perfect signals, propably not enough retries to send. After upgrading to 4.5 everything looks like its fixed but its not. I did ...

Im unable to select turbo mode on card Senao NMP-8602 PLUS (FCC)
Does this card support Turbo more (108mbit) ?