But you didn't answer my 3 questions.i think noise floor or snr says little about the real situation
the real and important measurement its signal vs interference, only can be measured with spectrum analyzer
makes it to the other side of the tunnelBy preserve do you mean it makes it to the other side of the tunnel? Or do you mean it moves the marking up a level to the tunnel IP header?
I tried 6.20, does the same error AND does a reboot loop; tried 6.7; 6.12 and 6.15 no luck either.Any chance that you are installing a version lower than 6.20?
Also, have you updated the firmware to 3.19?
what is the advantage of being in a switch group and not being in it?You can do slaves only within one common switch group. Enslavement means join the ports in switch. But if there is no switch chip you can just bridge the ports thru cpu.
I have read the wiki many times but it does not provide good information.You can set those in /ip dhcp-server option. I don't use it but I know where to set it.
http://wiki.mikrotik.com/wiki/Manual:IP ... CP_Options
yea but that default gateway is dynamic from pppoe and it is not on the same subnet as 213.x.x.x/29You only need in default gateway per router. You mention that PPPoE is giving you a default gateway.
ok but the default gateway 78.x.x.x is not on the same subnet as the public ip 213.x.x.xThat subnet is being routed to you via the pppoe connection from your isp
MadEngineer thank you so much!is there a route for destination 172.16.0.0/24? What is the routing table on the device you're trying to ping them from?