I know this is a tricky one, I had no luck in the beginner forums. I wanted to move the topic, but couldn't figure out how, so this is a re-post. I am trying to send broadcast/multicast traffic (DLNA) over a VPN, from a media server(Plex) on a different network. What is the correct method to do this...

Can I move this to "Forwarding Protocols" forum, as I don't think "Beginner Basics" is the right place for it. Or do I need to re-post?

I know this is a tricky one.

I am trying to send broadcast/multicast traffic (DLNA) over a VPN, from a media server on a different network.

What is the correct method to do this? PIM or IGMP Proxy? and what would the config look like.
Below is my network.
Thanks,

Hi I have the setup in the diagram. I am trying to use DLNA (broadcast) on the smart TV over the IPSEC VPN. The VPN is working fine, ping ect... However I know broadcasts wont work between two networks. Is there a way I can forward the broadcasts in both directions? I think I need to use IGMP-Proxy ...

I've managed to get it working. I trided using a switch insted of a bridge and it worked.... went back to a bridge as above and its now working. Not sure, maybe it was a config issue? maybe it just needed a reboot. What would be the best way to bandwith limit the server interfaces. I tried to limit ...

Hello All, I am having trouble with the following setup: Network.png For the WAN I have Bridged interfaces ether10 - ether7. The link from the ISP is on ether10. I have given the bridge an IP Address of 46.XXX.130.218. For the LAN I have Bridged interfaces ether1 - ether2, and setup Masquerade and V...

Me too....

VTP / GVRP / MVRP

Have a look at the video on this page.

http://gregsowell.com/?p=1290

Diffie-Hellman Groups Diffie-Hellman (DH) key exchange protocol allows two parties without any initial shared secret to create one securely. The following Modular Exponential (MODP) and Elliptic Curve (EC2N) Diffie-Hellman (also known as "Oakley") Groups are supported: Diffie-Hellman Group...

Hello,

I was on 5.24 and upgraded to 5.26.
Had the same issues....

Now running on version 6.11 and still the same problem.

So I think it is a configuration issue – maybe a mismatch. Anyone know what settings would cause a “none” “none” on the encryption/auth SAs?

Thanks

PS. Using version 5.26.

Did you get the same symptoms?

Anyone know what setting would cause “none” on the Auth/Encr Algorithms when looking at the SA’s ?

Hi All, I am having difficulty establishing a site-to-site IPSEC VPN with a 3rd party (FortiGate) from our mikrotik. I am getting “none” on the Auth/Encr Algorithms when looking at the SA’s. Below are some logs and my config. 10.43.54.0 is my local LAN and 192.168.101.0 is the Remote LAN. I can’t se...