Hi ,Try to set channel to 64800 in CLI, the attenuation in O2 is smaller in higher frequencyHello ,
our first long link. Great !!! firmware 6.42.5
Thanks. Do you know a script that remove all ip-binding of specific server ?with this script you can remove all ip-binding entries.
ros codeip hotspot ip-binding remove [find]
First stop, I must note that despite the name, having PEAR2 itself is not required.
Hello ,Just put the dst host dst port and protocol into walled garden ip list. I think thats it!
Hi , sorry for delayHello brasileottanta,
would you please so friendly and tell us first from which "other RB" you were taking the configuration backup?After restore a config from other RB , ..........
Fewi saysSpecific answers require specific questions. When in doubt, post the output of "/ip address print detail", "/ip route print detail", "/interface print detail", "/ip firewall export", and an accurate network diagram.
Thank's , problem resolved with a fresh installation . But , we don't know how .....try to disable proxy (in Hotspot, uncheck "Transparent proxy", AFAIR)
downgrade to v2.9.x will reset the wireless configuration.
OSbridge have a problem with PPPoE ...they mess with the mac of the pppoe server . Yet another thing to throw in the bin
Why ? No other 5ghz equipment in area ( lab test )For two reason:
- the simpliest: there's lower noise on 5800 than 5500;
We have tested without antenna , on lab.- your antenna is not correctly adapted to 5500.
Yes equal everithigs ....same channel, same no configuration (minimum = ssid, band, frequency ip)?
Where I violate the policy ? and isn't my volonty to violate ...I report a real problem !!!
Yes , I know that. Only for remark.Yes, you are right, but this is not MT, this is basic physics...
So , a BTS with -120 Noise Floor is better than a BTS with -90 Noise floor .. Correct ?Less noise is always better, so a low noise floor is better than a high one...But Sergejs , high noise-floor is better then low ? ( actually we have on a BTS -86dbm and on other -119/-123 )
We use a passive POE at 48V ( original equipment from mikrotik ) . But , we have change the antenna , from omni to panel , and now work fine .if you use the card with routerboard , do you have a proper powersupply ? under heavy load is this card is sucking up to 1500mA