No, both configurations are done from scratch with default settings first after the problems are coming with the news ROS. Editing of the Neighbor Discovery setting have not solve the problem. But setting on both units (AP and CPE) the MAC address of the unit's wireless interface as Admin MAC addres...

Hi,
Neighbor Discovery setting before:
bridge1 => enabled
ether1 => enabled
wlan1 => disabled

now set to:
bridge1 => enabled
ether1 => disabled
wlan1 => disabled

Thanks. I will report the result after 24 h monitoring.
best regards, Frank

Same problem on CPE with ROS 6.38.5
AP with ROS 6.38.5 als AP bridge, CPE configured as station bridge. bridge1 with wlan1 and ether1

Only this one CPE is connected with the AP, on eth of the CPE a laptop is connected. No switches are playing in this setup.

thanks, Frank

Thanks for the hint.
It's a option that will work for me.
Best regards Frank

Hi, I'm connected to a CPE device using a wireless connection. If I do start a wireless scan on this CPE device, der wireless connection to the AP is interrupted. On DD-WRT it's possible to do this. I need this feature to see, if near the CPE another system using the same wireless channel like the C...

Thanks, it's working.
My bad was the wrong mark direction of the source port. Now everything is working fine.

thanks, Frank

did noboady has a solution?

Hello, have configured NAT, Wireless is a client of an AP, LAN 192.168.1.0/24 on ethernet port 3. I see in Torch such connection: Src: 192.168.1.171:52203 Dst: 100.100.100.100:5000 The src host has initiated a ssh connection to dst and loads from the dst host data down. (Tx Rate: 21 MBit, Rx Rate 17...

If I have opened a firewall rule, a Button to clone this rule.

I have a lot of INPUT rules, which are only different by the src IP Address.
So I can clone the rule, change the SRC IP and apply the rule.
Webmin (www.webmin.com) have it implemented for the firewall settings.

thanks
Frank

okay, thanks for the hint. The serial cable will be my new (old) friend.
I have now setup the AP step by step and it's working very well.

The work around with the scheduler is a very good idea. This is a safe fall back to the local network for acessing the bridge.
Thanks.

best regards
Frank

no, have not used connectivity via MAC. Will try it next week.
Thanks for the useful hints, have now many ways to play.

thank
Frank

Yes directly via Webfig. Laptop has 192.168.88.21/24
Ethernet port with PoE label is used. Power not via PoE injector.

Thank, Frank

Hello, I have setup a PTP Bridge with AP (server/AP) and client (Client/CPE) within a few click without any problems. No I want to change to AP bridge mode (to connect more than one client) and have set the following: - AP Quickset - Mode: bridge - Address Acquisition: Static - IP Address: 192.168.8...