Community discussions

MikroTik App

Search found 9 matches

by ssaliba
Thu Apr 18, 2024 9:11 pm
Forum: Containers
Topic: Upgrade to 7.14.1 on hap ax3 broke my containers
Replies: 8
Views: 1139

Re: Upgrade to 7.14.1 on hap ax3 broke my containers

That's great news. Looking forward for the next release then.
by ssaliba
Tue Apr 16, 2024 11:57 am
Forum: Containers
Topic: Upgrade to 7.14.1 on hap ax3 broke my containers
Replies: 8
Views: 1139

Re: Upgrade to 7.14.1 on hap ax3 broke my containers

Thanks for sharing your experience upgrading the AX3 to the new firmware. To be honest, I thought it was only me having these issues. I hope the Mikrotik dev team is following up on this feedback as sometimes I feel users report issues with the software but the Mikrotik team are living in their own ...
by ssaliba
Thu Mar 21, 2024 11:34 pm
Forum: Containers
Topic: Upgrade to 7.14.1 on hap ax3 broke my containers
Replies: 8
Views: 1139

Upgrade to 7.14.1 on hap ax3 broke my containers

Reaching out to warn against upgrading hap ax3 to 7.14.1 if you are using containers. I had a lot of issues with the containers not starting and the router rebooting after the upgrade . Downgrading to 7.13.5 solved the issue. Has anyone encountered similar issues ?
by ssaliba
Sat Jan 13, 2024 12:10 pm
Forum: Wireless Networking
Topic: Wifi connection issues on slave configuration
Replies: 6
Views: 1264

Re: Wifi connection issues on slave configuration

Thanks for the tip. Using the slaves-datapath did the trick too and it was automatic without manual intervention
by ssaliba
Sat Jan 13, 2024 12:10 am
Forum: Wireless Networking
Topic: Wifi connection issues on slave configuration
Replies: 6
Views: 1264

Re: Wifi connection issues on slave configuration

I seem to have resolved the issue. Unlike the legacy CAPSMAN which allows the selection of a bridge to which interfaces should be added when local forwarding mode is used, the new CAPSMAN only supports local forwarding but does now allow for the specification of such bridge. I added the slave wifi i...
by ssaliba
Thu Jan 11, 2024 3:18 pm
Forum: Wireless Networking
Topic: Wifi connection issues on slave configuration
Replies: 6
Views: 1264

Wifi connection issues on slave configuration

I have a strange issue when provisioning a Slave Configuration using CapsMan on a hAP ax3. The Master config works without issues but whatever slave configuration I add I always have the same symptom. The device sucessfully connects and disconnects within seconds. The only logs available are the one...
by ssaliba
Mon Aug 18, 2014 12:46 pm
Forum: General
Topic: IPSec traffic from within the router cli
Replies: 3
Views: 1037

Re: IPSec traffic from within the router cli

Hi

Thanks for your reply. I tried as you suggested but it still did not work. When I added the route it gave me an unreachable state . Any ideas ?
by ssaliba
Wed Aug 13, 2014 5:57 pm
Forum: RouterBOARD hardware
Topic: Issue with RB2011L-RM
Replies: 1
Views: 1003

Issue with RB2011L-RM

I have a strange issue with an RB2011. When I power it on it does not boot properly and I can't connect to it for management. If I perform a hardware reset using the reset switch at the back of the router, it will boot fine. Once I power cycle again though I'm faced with the same problem. Anyone has...
by ssaliba
Wed Aug 13, 2014 5:47 pm
Forum: General
Topic: IPSec traffic from within the router cli
Replies: 3
Views: 1037

IPSec traffic from within the router cli

I've set an IPSEC tunnel between two mikrotiks and it works fine. The only thing I noticed is that when I try to ping traffic on the remote network from within the router cli I'm being routed to the default gateway rather then the IPsec tunnel. Is there a way around to this problem ?