Because i would like to get to know the physical possition of each and every one AP without having to physically uninstall the AP to view the S/N or MAC address.

Is there a way to create a configuration at Capsman so each cap will create an SSID with its identity? e.g. cap with identity AP01 when assigned the configuration profile through capsman will create the SSID "AP01" and with the same configuration assigned AP02 will create the SSID "AP...

I have the following network. Any ideas on how to manage the LHGs?

No i meant something like that https://support.sonus.net/display/DSCDO ... Mware+ESXi
All hypervisors i know of have built in redundancy capabilities.
HyperV has dynamic teaming.

Haven't tried this before with a hypervisor, but you could probably:

• Bridge the two 10G interfaces of the hypervisor

• Configure RSTP

This way you would have redundancy, but no throughput aggregation.
The same applies for firewalls.

A solution was to make ether1 a trunk and passtrhough LTE over a vlan. Another solution -which i followed- is to create an EoIP tunnel to passthrough the LTE over it.

Dear all,

i have a wAP LTE kit with LTE interface configured in passthrough mode for ether1 port. When the LTE connection becomes active i loose connectivity to the wAP LTE kit through ether1. Anyone with the same issue?

panosla - Please note that RouterOS version does not in any way affect Netinstall process. Can you Netinstall any other RouterBOARD just to be sure that configuration is correct and computer is not blocking Netinstall process? Sorry, my bad. I was actually trying to netinstall using ether2 instead ...

Update to 6.41 bricked my RB750Gr3. In goes into continues boot loop and it is undiscoverable to even perform netinstall.

Yes it works for sure. I have it working on my home lab for about 6 months now. What seems to be the problem? (The forest and domain functional level is 2012) Here is the export with some garbage from the pre-capsman era. (I don't believe they are needed, but i never bothered deleting them) /caps-ma...

This setup would require three routers instead off two.
I'm looking for a way to somehow approach the requirements and results of Cisco's GLBP

Good evening everybody!

i have two internet connections on a LAN using them for failover if one of the router fails(VRRP).
Is there a way to utilize the second internet connection without PCC in a more scalable way such as BGP?

Good evening, i tried to use ZTE 667 for internet connection on a hAP(951). It works, but with one problem. When the router is powered up the interface does not exist. You must perform a soft reboot in order to get connected. If you hard reboot (disconnect power), the ZTE 667 disappears. I believe t...

Good evening, i would like to use something like that http://pi.worldpossible.org/ to provide offline content, to a disconnected, from the rest of the internet, network. I have managed to perform all necessary configuration except from one thing, when the mikrotik is not connected to the internet, t...

Any solutions yet?

I cannot add a new device profile if another one exists with the same IP and Username

Is DHCP option 138 suitable for configuring CAPsMAN address on all CAP enabled devices?

Setup correctly Channel and Extension Channel

Uncheck tkip and WPA and try again

I want to create a failover configuration for CAPsMAN through VRRP. I've managed to reach this far, meaning, my CAPsMAN system works ok and when the primary manager fail, all the CAP failover to the secondary manager. I want to take this installation one step further and use certificates (Preshared ...

WinBox 3rc12 crashes when trying to create virtual ethernet on hap lite 6.29.1

Is it possible to create a IPIP tunnel using dynamic IP on both ends?