So, where, and how did you changed the route cache seetings ?So... now it's working as expected and the culprit for the 200 ~ Mbps issue was? Route cache disabled..
Why, instead of whining, don't you just try?
No need to downgrade.
Why do you need two bridges?
Did your routes set propely ? Did your firewall rules set properly ?
- LAN hosts does not communicate with mikrotik
- The mikrotik does not communicate with LAN hosts
port scanner drop: 192.x.x.x:59842->192.x.x.255:20561.
@CsXen can you please give me a guide or something on how to boot into an OpenWRT image over tftp ?
Terminate the ovpn-session too, when you disable the ppp-out1.So if I want to change IP address, in my case I need to wait around 3 minutes.
How can I short that time?
RB951 uses 12V or 24V power supply. 5V is not enough for it.i tried by replace power supply 5v 1a but nothing change
Can you tell me please, how can I upgrade my RB532A (mipsle) to this level ?Upgrade to v6.38.5 or above should fix the issue and clean your system.
remote SITE_OF_3RDPARTY_VPN.com 1194 udp
+1. On my old RB112 with ROS 5.26, I see the same issue. Connecting... forever. I tried on ETH and over wifi.Version 0.0.12 Not working with ROS 5.26 , i can see in ROS logs "user admin logged in from .... via winbox" but on phone it shows connecting ...
/interface bridge filter add action=drop chain=input comment="Deny DHCP over Bridge" src-port=68 dst-port=67 in-interface=Bridge1 ip-protocol=udp mac-protocol=ip
:put [/system license get software-id ]